RunRyder RC
WATCH
 1 page 82 views Post Reply
05-13-2021 10:20 PM  42 days ago
Topic Vote0Post 1
therocket1978

rrNewbie

London

MyPosts All Forum Topic
Robbe Hc3sx
Hi

I was looking for some advice and guidance
I am trying to set up the the Hc3sx robbe now BavarianDEMON

I don’t understand where and how the wiring loom goes on the Hc3sx
And which wires go to the receiver
I get connected on the computer
But when I try to move any sticks on the radio I get nothing
SHARE  PM  EMAIL  GALLERY  Attn:RR  Quote
05-14-2021 04:43 PM  41 days ago
BarracudaHockey

rrMaster

Jacksonville FL

MyPosts All Forum Topic
The wire loom only fits one way, the wiring layout is detailed in the manual. Just ensure the single wires plug in so that they are where the signal wires of the rest of the servos are, opposite where the ground wires are plugged inAndy
AMA 77227
http://www.jaxrc.com
SHARE  PM  EMAIL  GALLERY  Attn:RR  Quote
05-15-2021 01:11 PM  40 days ago
modtron

rrKey Veteran

Oxford. UK

MyPosts All Forum Topic
As mentioned above, the connections are very clearly covered in the manual - assuming that you have one ?
Then just follow the "Set Up Wizard" for al of the configuration.

modtron
Oxford UK
SHARE  PM  EMAIL  HOMEPAGE  GALLERY  Attn:RR  Quote
05-15-2021 01:34 PM  40 days ago
BarracudaHockey

rrMaster

Jacksonville FL

MyPosts All Forum Topic
Here you go. Note the loom inserts at the 2nd set of pins with the ground (black) wires to the outside of the case.

Andy
AMA 77227
http://www.jaxrc.com
SHARE  PM  EMAIL  GALLERY  Attn:RR  Quote
WATCH
 1 page 82 views Post Reply
Print TOPIC

 2  Topic Subscribe

Friday, June 25 - 1:40 am - Copyright © 2000-2021 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online