RunRyder RC
WATCH |
1 page 75 views | Post Reply |
| RunRyder | RunRyder |
|
|
0| jtdesert
rrNovice Kremmling CO USA |
Microbeast plus Verision 5.1 Setup menu point H - swashplate servo trim. Manual says initially when trimming is 0 on all servos the status LED will be off. Can't get it off everytime go to H it shows purple no matter what I do. I have two versions 4.1 on other heli's but this version giving me problems. Can anyone help.
Trex 600 ESP converted to FBL. AR8000 receiver...DX8 radio |
| SHARE PM EMAIL Attn:RR Quote | |
 Rojoalfa
rrKey Veteran Punta de Mata, Monagas-Venezuela |
/Ok... Menu GSwashplate Servo center trimInstruction manual said:"Only the trimmed servo positions are important and get stored (those which have been set with the corresponding Status-LED colors). The servo positions at “Status-LED off“ only serve for reference and to get the servo horns best plugged into position, for instance if you install new servos or replace the servo gears after a crash. This reference position will not be used later onwards. Only the servo positions with active trimming are used."Then, point this..."Now if servos are trimmed do not yet proceed to the next menu point. With active trimming (Status-LED still lights up in one color!) adjust the linkage rods according to your helicopter manual.So, it doesn't matter the color of status led at this time.(purple, red or blue)At the end, you need to push the button to memorize./ |
| SHARE PM EMAIL GALLERY Attn:RR Quote | |
| jtdesert
rrNovice Kremmling CO USA |
|
| SHARE PM EMAIL Attn:RR Quote | |
WATCH |
1 page 75 views | Post Reply |
| RunRyder | RunRyder |
|
|
Tuesday, March 9 - 1:15 am - Copyright © 2000-2021 RunRyder EMAIL • Enable Cookies
