WATCH |
1 page 174 views | Post Reply |
RunRyder | RunRyder |
![]() |
![]() |
PaulBowen
rrKey Veteran Australia |
Logo Motor Optimisation G’dayMy Logo 550SX is currently operating with the smallest pinion possible and giving 12 minutes governed at 60% on the YGE 90LV and Scorpion HKIII4025-1100 using 80% of the 6s5000 pack.I would like to fit an 850Kv motor in the heli to bring the governed throttle back up to 80% hopefully gaining some further flight time. The two options are as follows;Hacker A50-8S Turnado V3 850Kv (my preference), orScorpion HKIV-4025-850Kv with 5mm shaft kit.The timing can’t be changed on the Mikado supplied YGE and I can’t find a program card anywhere regardless. My question is wether or not the Hacker will work properly with the YGE and will the ESC automatically change the timing to suit the motor. Scorpion say timing should be 5deg whereas Hacker say 15-20deg.JR Propo Ergo 30, OS 32SX-H, Edge 550, Edge 90. Futaba T18SZ |
SHARE PM EMAIL GALLERY Attn:RR Quote |
![]() rrKey Veteran Punta de Mata, Monagas-Venezuela |
PaulBowen My question is wether or not the Hacker will work properly with the YGE and will the ESC automatically change the timing to suit the motor. Scorpion say timing should be 5deg whereas Hacker say 15-20deg. /I understand that this type of ESC adjustment can't be automatic. You need to do the setting in a manual way.If you don't do this adjustment, the motor is going to run hotter and inefficient./ |
SHARE PM EMAIL GALLERY Attn:RR Quote |
PaulBowen
rrKey Veteran Australia |
JR Propo Ergo 30, OS 32SX-H, Edge 550, Edge 90. Futaba T18SZ |
SHARE PM EMAIL GALLERY Attn:RR Quote |
![]() rrKey Veteran Punta de Mata, Monagas-Venezuela |
/This type of answer from the dealers, always make me nervous.Hacker Tornado motor is 20 degree timing and it is outrunner.YGE ESC has this default :Inrunner motor from 0 to 12 Outrunner motor from 18 to 30Instruction manual said nothing about the default mode which could be outrunner or inrunner or autotiming.So, you need an additional step to make sure you are with the correct motor default./ |
SHARE PM EMAIL GALLERY Attn:RR Quote |
PaulBowen
rrKey Veteran Australia |
JR Propo Ergo 30, OS 32SX-H, Edge 550, Edge 90. Futaba T18SZ |
SHARE PM EMAIL GALLERY Attn:RR Quote |
![]() rrKey Veteran Punta de Mata, Monagas-Venezuela |
PaulBowen I can’t find a program card anywhere regardless. /I visit web page from YGE and they were explained a software pc available. (New PC-Software V0.980) http://www.yge.de/en/home-2/It was not clear to me, if you need a special USB dongle to program the ESC, instead of programing card./ |
SHARE PM EMAIL GALLERY Attn:RR Quote |
WATCH |
1 page 174 views | Post Reply |
RunRyder | RunRyder |
![]() |
![]() |
Sunday, February 28 - 10:46 am - Copyright © 2000-2021 RunRyder EMAIL • Enable Cookies