WATCH |
1 page 174 views | Post Reply |
RunRyder | RunRyder |
![]() |
![]() |
jondv
rrNovice United Kingdom |
Align 500e Pro Hello,
Been while since on here, my issue is doing rebuild of above helicopter.The problem have is checking linkage lengths, on head In manual on page 8 the 2 linkages A, say should be 31.5mm, is this miss print as don’t think this is correct, hopefully someone can enlighten me on this. ![]() |
SHARE PM EMAIL Attn:RR Quote |
![]() rrKey Veteran Kansas City |
![]() |
SHARE PM EMAIL GALLERY Attn:RR Quote |
jondv
rrNovice United Kingdom |
|
SHARE PM EMAIL Attn:RR Quote |
![]() rrKey Veteran Punta de Mata, Monagas-Venezuela |
/Be sure you are using the correct link that should be shorter.Don't care about length. You need to follow the link separation of 2.5 mm.This double link are very important because you may need it to adjust when doing the blade tracking, later on./ |
SHARE PM EMAIL GALLERY Attn:RR Quote |
jondv
rrNovice United Kingdom |
Must be miss print on manual |
SHARE PM EMAIL Attn:RR Quote |
![]() rrKey Veteran Punta de Mata, Monagas-Venezuela |
/I see your point.Most of the measures of length we found on instructions manual are from center hole of each link.I don't know but I can see that this particular double link, the measure is not as always. It appears to go from the top of link's hole... ![]() |
SHARE PM EMAIL GALLERY Attn:RR Quote |
jondv
rrNovice United Kingdom |
Thank you all again for the input ![]() |
SHARE PM EMAIL Attn:RR Quote |
WATCH |
1 page 174 views | Post Reply |
RunRyder | RunRyder |
![]() |
![]() |
Thursday, February 25 - 1:20 pm - Copyright © 2000-2021 RunRyder EMAIL • Enable Cookies