Vario and Axon

rrTV-PHOTO GALLERIES MY GALLERY HELP-FAQ

myHOME PM pmRR MEMBERS 286 ONLINE 1 EVENTS SEARCH REGISTER START HERE

WATCH

1 page 312 views

Post Reply

RunRyder	RunRyder

Home › Scale › ✈️Aircraft › Scale Heli › Scale Helicopter Main Discussion › Vario and Axon

06-12-2020 12:03 AM 16 months ago

Topic Vote

0Post 1

bmfrd

rrNovice

Maryland

MyPosts All Forum Topic

Vario and Axon

I have a question for those that use the Bavarian Demon Axon FBL control unit. In the set up, it states that the tail should have zero degrees for initial setup. However, the Vario tail has an offset built in to give some deflection with the arm at 90 degrees.

My question is, should I ignore this or reset the tail to 0?

SHARE PM EMAIL GALLERY Attn:RR Quote

06-12-2020 08:53 AM 16 months ago

0Post 2

modtron

rrKey Veteran

Oxford. UK

MyPosts All Forum Topic

Ignore what you are seeing as this is primarily for use with 3D heli's.

Set the neutral of the tail servo with the arm at 90 degrees to the body, then adjust the length of the tail pushrod to get the tail bell crank arm parallel with the tail output shaft.
This will then set the tail blades to virtually the correct neutral position.
Then you can adjust the travel / range to suit in the gyro menu.

modtron
Oxford UK

SHARE PM EMAIL HOMEPAGE GALLERY Attn:RR Quote

WATCH

1 page 312 views

Post Reply

RunRyder	RunRyder

Home › Scale › ✈️Aircraft › Scale Heli › Scale Helicopter Main Discussion › Vario and Axon

Print TOPIC

2 Topic Subscribe

New Subscriptions

Buddies Online