WATCH |
1 page 202 views |
Post Reply |
05-13-2020 12:35 AM 9 months ago
visualquest
rrNovice NC |
Align GPRO with Spectrum DSMX receiver will not bind. Installed Align GPRO with Spectrum 9745 DSMX receiver. After initial software setup then disconnecting esc then re-connecting, receiver goes into bind mode (steady flashing light) as it should. After powering on radio and preceding with binding it attempts then I get BIND FAILED. The receiver light then goes off completely. Any ideas? |
SHARE PM EMAIL GALLERY Attn:RR Quote |
05-13-2020 10:54 PM 9 months ago
Rojoalfa
rrKey Veteran Punta de Mata, Monagas-Venezuela |
/
/I understand that also you need to run the setup program.Follow this link...Watch at YouTube /Saludos cordiales, |
SHARE PM EMAIL GALLERY Attn:RR Quote |
05-13-2020 11:11 PM 9 months ago
visualquest
rrNovice NC |
Thats the video I watch to set it up to begin with. I chose DSMX for receiver seeing my radio and receiver is DSMX. Everything went well until the receiver went into bind mode as it should have....At this point the radio will not bind. It comes up bind fail and the receiver lights just go off. So now when I connect esc the receiver is always in bind mode. |
SHARE PM EMAIL GALLERY Attn:RR Quote |
05-14-2020 08:25 PM 9 months ago
balsabasher
rrVeteran Central Ohio, USA |
If you have a spare main DSMX receiver, attach your remote receiver to it and bind to the transmitter model location you are using for the heli. Then detach the remote receiver from the main receiver and install the remote to to the gyro. Should still show bound to your transmitter when you power up.Blades; what goes around, comes around! |
SHARE PM EMAIL GALLERY Attn:RR Quote |
05-15-2020 03:21 AM 9 months ago
visualquest
rrNovice NC |
Wow if I only had a spare DMSX receiver. I have a non-DSMX AR600 I threw in just to see if it would bind and it did without fail. Obviously thats not a DSMX receiver and has to connection for DSMX SAT. Had a fellow Flybarless guy tell me it sounds likes different frames rate. However you cannot change that on the DX6E that Im aware of. |
SHARE PM EMAIL GALLERY Attn:RR Quote |
WATCH |
1 page 202 views |
Post Reply |
2 Topic Subscribe
Sunday, March 7 - 8:48 pm - Copyright © 2000-2021 RunRyder EMAIL • Enable Cookies