RunRyder RC
WATCH
 1 page 418 views Post Reply
HomeRC & Power✈️Aircraft🚁HelicopterFlybarless Rotor Head SystemsBrain iKon › Brain/iKon Throttle Servo on Nitro install?
09-02-2019 11:53 AM  18 months ago
Topic Vote0Post 1
meowguy

rrVeteran

Saco, ME

MyPosts All Forum Topic
Brain/iKon Throttle Servo on Nitro install?
I have my throttle servo matching the direction of travel on Panel 6. That allows me to center the swashplate on Panel 8 because Brain thinks the throttle is low. However, as far as the motor is concerned the throttle is working backwards. How to do I get the throttle going the correct way to fly the machine.
"Sweet dreams and flying machines in pieces on the ground." J. Taylor
SHARE  PM  EMAIL  GALLERY  Attn:RR  Quote
09-02-2019 01:06 PM  18 months ago
ICUR1-2

rrElite Veteran

Ottawa, Ontario

MyPosts All Forum Topic
panel 12 governor set up you adjust the end points and servo travel and servo reverse is therespending time, paying attention
SHARE  PM  EMAIL  GALLERY  Attn:RR  Quote
09-02-2019 01:36 PM  18 months ago
meowguy

rrVeteran

Saco, ME

MyPosts All Forum Topic
ICUR1-2 panel 12 governor set up you adjust the end points and servo travel and servo reverse is there
Thank you. Perhaps Brain could mention that on panel 6 in the side bar.
"Sweet dreams and flying machines in pieces on the ground." J. Taylor
SHARE  PM  EMAIL  GALLERY  Attn:RR  Quote
09-02-2019 03:05 PM  18 months ago
ICUR1-2

rrElite Veteran

Ottawa, Ontario

MyPosts All Forum Topic
Yep it was a learning process for me. I learned allot trying to tune my tail on a 600N thanks to msh customer support spending time, paying attention
SHARE  PM  EMAIL  GALLERY  Attn:RR  Quote
09-29-2019 05:40 AM  17 months ago
keiser BLADE

rrApprentice

WV USA

MyPosts All Forum Topic
good to know im about to setup 2 nitro machines ,thanks guysBrandon
SHARE  PM  EMAIL  HOMEPAGE  GALLERY  Attn:RR  Quote
WATCH
 1 page 418 views Post Reply
HomeRC & Power✈️Aircraft🚁HelicopterFlybarless Rotor Head SystemsBrain iKon › Brain/iKon Throttle Servo on Nitro install?
Print TOPIC

 2  Topic Subscribe

Sunday, February 28 - 7:34 pm - Copyright © 2000-2021 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online