RunRyder RC
WATCH
 2 pages [ <<    <     1     ( 2 )    >    >> ] 206 views POST REPLY
HomeMy Site✈️Aircraft🚁HelicopterHelicopter Main Discussion › tail wag in thunder tiger 550 with ikon 2 and DX9
12-31-2018 05:36 PM  6 months ago
motorrc

rrApprentice

canton ohio usa

MyPosts All Forum Topic
InvertedDude
Tail rod is it smooth or sticky?
Gyro flybarless tape solid mount none moving?
Does your helicopter have crazy vibes?
Have you done the reset again on your Ikon?

Do you have another flybarless gyro to test?
rechecked tail rod assembly as per icur1-2, smooth movement, no binding.
gyro well mounted.
Has some vibs (see earlier posts) I believe are tail rotor related. Have you found a good way to balance the tail rotor?
reset?? I checked the tail settings
This is the second gyro. Its is brand new out of the box.
if it doesn't fit, make it fit.
SHARE  PM  EMAIL  Attn:RR  Quote
12-31-2018 05:48 PM  6 months ago
InvertedDude

rrVeteran

USA

MyPosts All Forum Topic
motorrc
I swapped my CF blades to KBDD tail blades.

Why not try a different complete tail system to see if you can remove the vibes.

My freya 91 was a PITA to cure...took a lot of time and engine tuning to get it right enough and RPMS to avoid the death vibes.

If your helicopter is belt driven, back off the pressure a little to see if that helps?
SHARE  PM  EMAIL  GALLERY  Attn:RR  Quote
12-31-2018 06:09 PM  6 months ago
Big Edge

rrApprentice

Oldsmar, FL USA

MyPosts All Forum Topic
How far out is the ball link on the tail servo arm?-----------------------------
Don't taze me bro...
SHARE  PM  EMAIL  GALLERY  Attn:RR  Quote
01-01-2019 02:16 AM  6 months ago
ICUR1-2

rrElite Veteran

Ottawa, Ontario

MyPosts All Forum Topic
You say there's a vibration ?

Take the blades off and get ready to start testing. Through process of elimination.
remove the tail rotor and spin it up to less than full throttle.
If it's gone it was the rotor.
Do same for rotor head .

On my 600N I had to Chase a vibe down to the clutch bell.
I kept removing assembly until it was gone
Spinning up each assembly after a crash is tedious even balancing doesn't catch a bad bearing .
spending time, paying attention
SHARE  PM  EMAIL  GALLERY  Attn:RR  Quote
WATCH
 2 pages [ <<    <     1     ( 2 )    >    >> ] 206 views POST REPLY
HomeMy Site✈️Aircraft🚁HelicopterHelicopter Main Discussion › tail wag in thunder tiger 550 with ikon 2 and DX9
 Print TOPIC  Make Suggestion 

 8  Topic Subscribe

Tuesday, July 16 - 1:05 am - Copyright © 2000-2019 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online