WATCH |
1 page 232 views | POST REPLY |
Scorpion Power | RunRyder |
![]() |
![]() |
Airwolf1007
rrNovice South Africa |
JR 11x Zero with DMSS module help needed please. Good Day.I have a JR 11x Zero with the DMS2 module in, so I did the software update to accommodate the DMSS protocol.So, now on the modulation menu I have DMSS - DMS - SPCM - PPM9 - PPM8 , I installed a new DMSS module with the male to male adapter pin for telemetry , I switch on the radio and go the modulation menu and set it to DMSS from there I go to the bind menu. I can not get my DMSS receivers to bind, I have 4 receivers no luck.
I try to bind from the bind menu and also from , holding down the bind button at the module then switch on the radio to bind , no luck.The blue light on the module is blinking very fast, not solid blue.Have anyone done this before? am I doing something wrong or is the module faulty?Regards |
SHARE PM EMAIL GALLERY Attn:RR Quote |
![]() rrProfessor Sherwood, Arkansas 💎Sustaining Member |
XG 11 MV On my tx, when I turn the radio on with the module installed, I have to OK the RF before a signal will be sent... so my procedure is this:
Turn on the tx and power up the rx...then while holding the button on the module hit the button on the front of the tx that says RF OK...that should bind the two.. I hope this might help you with your set up..Stan ![]() |
SHARE PM EMAIL GALLERY Attn:RR Quote |
Airwolf1007
rrNovice South Africa |
It sounds like you have the old firmware, or you use your module in PPM modulation. I have the new firmware with that I don't have the on off option at the start up screen in DMSS modulation and with that I also have a binding option in the menu. The blue light at the back of your module is it solid blue?Regards Neels |
SHARE PM EMAIL GALLERY Attn:RR Quote |
Airwolf1007
rrNovice South Africa |
![]() ![]() |
SHARE PM EMAIL GALLERY Attn:RR Quote |
![]() rrProfessor Sherwood, Arkansas 💎Sustaining Member |
Different I am using the AirMod in mine.. tx is version 2000-0013
So mine is different then your tx.. Oh well, tried to help out!!! ![]() |
SHARE PM EMAIL GALLERY Attn:RR Quote |
Airwolf1007
rrNovice South Africa |
so it is confirmed that the module is faulty. now comes the next problem to get the hobby shop to exchange it for a other new (working) one. Thank you for all the advice. |
SHARE PM EMAIL GALLERY Attn:RR Quote |
![]() rrProfessor Sherwood, Arkansas 💎Sustaining Member |
Exchange Hope they treat you right..Stan |
SHARE PM EMAIL GALLERY Attn:RR Quote |
WATCH |
1 page 232 views | POST REPLY |
Scorpion Power | RunRyder |
![]() |
![]() |
Print TOPIC | Make Suggestion |
Monday, December 9 - 6:41 pm - Copyright © 2000-2019 RunRyder EMAIL • Enable Cookies