RunRyder RC
WATCH
 1 page 190 views POST REPLY
Home✈️Aircraft🚁Helicoptere-BladeBlade Nano CPS › Nano cps pitch issues
08-01-2018 04:39 AM  16 months ago
Topic Vote0Post 1
venture_flyer

rrApprentice

Fredericksburg VA

MyPosts All Forum Topic
Nano cps pitch issues
Guys trying to get this little heli going so I can have some fun! The issue is when I setup the throttle and pitch curve as the manual says the heli isn't working right. The pitch curve mimics the throttle curve.Below is my settings:
Throttle
N= 0,50,100
1=100,85,100
2=100,100,100
Pitch
N=30,50,100
1=0,50,100
2=0,50,100

When flying normal everything is good. Forward flight is good and hovers are good. When I flip in idle up1 the throttle curve acts as it suppose to but the pitch goes 100% positive. As I move the stick towards half stick I get about 80% positive pitch then at high stick 100% positive pitch. I have checked all the settings but I never get negative pitch outside of normal mode. Any ideas or trials.

Equipment:
Blade Nano CPS
JR 9503 2.4ghz.
US Marine Corps 98-06. Disabled veteran of Operation Enduring Freedom and Operation Iraqi Freedom.
SHARE  PM  EMAIL  GALLERY  Attn:RR  Quote
09-23-2019 08:28 AM  84 days ago
KG KG

rrNovice

Daly City

MyPosts All Forum Topic
I have this same issue...
SHARE  PM  EMAIL  Attn:RR  Quote
09-24-2019 12:50 PM  82 days ago
rpat

rrElite Veteran

Weirton, W. Va.

MyPosts All Forum Topic
hhhmmmtrex 700fbl cal30,minititan,, trx600fbl,trex250,logo 500,Velocity N2
SHARE  PM  EMAIL  GALLERY  Attn:RR  Quote
09-25-2019 01:57 AM  82 days ago
rpat

rrElite Veteran

Weirton, W. Va.

MyPosts All Forum Topic
Where did you get those settings for the pitch at?trex 700fbl cal30,minititan,, trx600fbl,trex250,logo 500,Velocity N2
SHARE  PM  EMAIL  GALLERY  Attn:RR  Quote
09-25-2019 04:08 AM  82 days ago
KG KG

rrNovice

Daly City

MyPosts All Forum Topic
I downloaded mine from spektrum site inspection installed from SD card onto my DX8 g2. I held rudder stick full right as I turned on my radio while holding the bind button I did not release until the light turn blue and bind was complete. When I switch the idle up one my swashplate slowly creeps full backwards and to the right and if I give any stick input in the opposite direction it immediately flips the swash plate to the opposite extreme impossible to fly but normal mode I can fly properly, but if I remove "b" switch from gear assignment and make it "a" switch. I could fly and use the idle up speeds, but I have no safe. I am confused as to what the blue light means in when you switch the gear switch or if the gear switch was still assign to switch be to idle of 1, that red light. I guess it means danger, but seriously someone fill me in on this.
SHARE  PM  EMAIL  Attn:RR  Quote
09-25-2019 12:04 PM  81 days ago
rpat

rrElite Veteran

Weirton, W. Va.

MyPosts All Forum Topic
OK the only advice I can give you is to call horizon. They are the ones that would know how to help you. You usually have to leave your phone number to a call back and they always return your call to help you.trex 700fbl cal30,minititan,, trx600fbl,trex250,logo 500,Velocity N2
SHARE  PM  EMAIL  GALLERY  Attn:RR  Quote
WATCH
 1 page 190 views POST REPLY
Home✈️Aircraft🚁Helicoptere-BladeBlade Nano CPS › Nano cps pitch issues
 Print TOPIC  Make Suggestion 

 2  Topic Subscribe

Monday, December 16 - 10:14 am - Copyright © 2000-2019 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online