RunRyder RC
WATCH
 1 page 184 views POST REPLY
Home✈️Aircraft🚁HelicopterFlybar Rotor Head Systems › BeastX 4.2 NITRO GOV w/ DX8 help!
07-17-2018 01:17 AM  19 months ago
Topic Vote0Post 1
S76 Mech

rrElite Veteran

Hatboro, Pa.

MyPosts All Forum Topic
BeastX 4.2 NITRO GOV w/ DX8 help!
Back into intro.

Setup a MBX plus 4.2 with nitro gov enabled on. Having issues with Gov channel going to full speed when I switch from Gov Off to Gov On. This is while the helicopter is flying. Not on the bench. I've got my Gov to aux3(gov) and assigned to my Gov 3 position switch. With a +90 at position O the Gov is OFF. I can fly on my regular curves.
As soon as I enable position 2 and 3 (66% & 67%) the headspeed goes full and doesn't come down. Scary ****.

What am I doing wrong here?
Thanks
Rick
Gaui Greatness X7, X5, NX4, X3
SHARE  PM  EMAIL  HOMEPAGE  GALLERY  Attn:RR  Quote
07-17-2018 04:56 PM  19 months ago
MOZENZ

rrNovice

Denby Dale UK

MyPosts All Forum Topic
Are you sure beast x is recognising magnet pulses, have you checked by turning engine over slowly. I use 3GX sensor distance is critical, if its missing pulses it will go to max rpm.
SHARE  PM  EMAIL  Attn:RR  Quote
07-18-2018 04:12 AM  19 months ago
S76 Mech

rrElite Veteran

Hatboro, Pa.

MyPosts All Forum Topic
I know the blue light lights up as it passes. I'll check the distance tomorrow. It should be as close as possible without touching. Correct?Gaui Greatness X7, X5, NX4, X3
SHARE  PM  EMAIL  HOMEPAGE  GALLERY  Attn:RR  Quote
WATCH
 1 page 184 views POST REPLY
Home✈️Aircraft🚁HelicopterFlybar Rotor Head Systems › BeastX 4.2 NITRO GOV w/ DX8 help!
 Print TOPIC  Make Suggestion 

 1  Topic Subscribe

Wednesday, February 19 - 5:03 pm - Copyright © 2000-2020 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online