RunRyder RC
WATCH
 1 page 188 views TOPIC CLOSED
06-15-2018 07:10 AM  15 months ago
Topic Vote0Post 1
Daved Gutierrez

rrVeteran

Chicago, IL

MyPosts All Forum Topic
Ikon 2/Xpert 3301 hv
Hello I have a set of Xpert 3301HV servos that are being used with an Ikon 2 and I seem to have a problem with one of the servos running hot (channel 2 elevator servo) the settings I was using first were 1520/333mhz and that particular servo was hot while the other 2 were just warm so I decided to lower the setting to 1520/233mhz and it seem to lower the temperature some but still feels much warmer then the other 2 servos. I have not tried to fly the model yet but this is what I found out when I was going through the initial set up, so I guess my question is do you think there is something wrong with that particular servo or am I using the wrong settings, these are the very first Xpert servos I own so what are your thoughts.
SHARE  PM  EMAIL  GALLERY  Attn:RR
07-18-2018 09:26 PM  14 months ago
ticedoff8

rrKey Veteran

Morgan Hill, CA. USA

MyPosts All Forum Topic
Daved Gutierrez Hello I have a set of Xpert 3301HV servos that are being used with an Ikon 2 and I seem to have a problem with one of the servos running hot (channel 2 elevator servo) the settings I was using first were 1520/333mhz and that particular servo was hot while the other 2 were just warm so I decided to lower the setting to 1520/233mhz and it seem to lower the temperature some but still feels much warmer then the other 2 servos. I have not tried to fly the model yet but this is what I found out when I was going through the initial set up, so I guess my question is do you think there is something wrong with that particular servo or am I using the wrong settings, these are the very first Xpert servos I own so what are your thoughts.
Lower it to 156Hz and see how much cooler they are.
On FBL gyros that do not offer the option to change the refresh, 156Hz is typically what they use.
And, you will not notice any difference in flying between 333Hz and 156Hz.
+ > ÷
Believe 1/2 of what you see and none of what you hear.
Fake News will be the downfall of our Republic!
SHARE  PM  EMAIL  GALLERY  Attn:RR
07-19-2018 12:27 AM  14 months ago
Daved Gutierrez

rrVeteran

Chicago, IL

MyPosts All Forum Topic
I did try that as well with the same results. That particular servo is not working properly it probably has a defective component.
SHARE  PM  EMAIL  GALLERY  Attn:RR
WATCH
 1 page 188 views TOPIC CLOSED
 Print TOPIC  Make Suggestion 

 2  Topic Subscribe

Sunday, September 22 - 1:10 am - Copyright © 2000-2019 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online