Ok this is the second AR7200 for me... the first one in my 300x is ROCK SOLID.. perfect..

the second one is in my KDS 450 (trex clone) and I just set it all up ..

tail is rock solid... response is great but hovering it around its kind of sloppy and wanders around a lot... drifts a bit mostly left and rearward.

I notice when holding the heli... and I twist it the tail responds FAST and hard... as the gyro should ... but the swash plate... it only responds like 25% of what my 300x does.. meaning if I tip it the swash moves the right direction... but it does not seem like its enough..

Now im not SUPER DUPER with these things... I follow the instructions best I can setting it up beyond that im pretty clueless..

so heres what I KNOW..

setting ... POTS all three are dead center...

in my radio the GYRO settings are at about 50%

what suggestions can I get... where do I start looking or what settings do I need to adjust (and why would be nice LOL)

thanks in advance!

WOW I cant believe no one has any suggestions even bad ones.. usually I get so many im confused.

Did you adjust the step J (teaching the cyclic pitch geometry) to 6 degrees using aileron with the blades in line with the heli (front to back) REGARDLESS of what colour light you got?

Are both helis set the same in Parameter B (control behaviour)?

Are you using the same expo or any expo in both models?

60% of the time, it works every time!

Boy it had been so long I forgot I asked about this here.

YES 6Deg for sure...

the setting on my 450 are HIGHER (like they are set to EXPERT)

it does not fly bad.. it just seem slow to react... it wanders a bit and is spongy

The BeastX Wiki is pretty informative. Learned a lot from that.

I recently came across something weird. I have a 2nd Blade 450X with the same AR7200BX, but for some reason the gyro and tail rotor, rud channel, are reversed from the other. Very weird.

Sounds like you need to increase the cyclic gain (pot 1). If it's slow to respond you should try it on transmitter mode and increase your dual rates for aileron and elevator.

60% of the time, it works every time!