Why won't the LCD programmer move beyond "Connecting ESC"?

RIP Roman Pirozek Jr.
Team Futaba USA
Team Kontronik USA
http://flysrw.com

You need to plug in the LCD programmer first and than plug in flight pack

- Scott

Did that. No good.

RIP Roman Pirozek Jr.
Team Futaba USA
Team Kontronik USA
http://flysrw.com

Try to Update firmware of LCD Programmer

Double check:
- you are using the correct connector from ESC
- leads are in the correct orientation
- wires are intact and properly secured to connector pins

If all checks out ..perhaps a faulty programmer.

- Scott

I’ll check another programmer or I’ll try n use the WiFi express. All cables anew in working condition and oriented properly. Hmmmmm.

RIP Roman Pirozek Jr.
Team Futaba USA
Team Kontronik USA
http://flysrw.com

I did this last nite. I wasn't using the port in the esc. I was trying to do it through one of the servo leads. Use the port in the end of the esc and it fired right up

Thanks Bro. I’m well aware of that port. Programmer has absolute latest firmware and I have two programmers. It simply won’t progress past that connecting screen. Programmer comes up on USB Link PC Program but the ESC doesn’t. Hmmmmmm

RIP Roman Pirozek Jr.
Team Futaba USA
Team Kontronik USA
http://flysrw.com

Try the stick method

I've got cases where the ESC's won't go into programming mode.

- Scott