RunRyder RC
WATCH
 1 page 437 views POST REPLY
HomeRC & Power✈️Aircraft🚁HelicopterRadio - Futaba FASST › Fail safe setting T10CG
12-29-2017 07:21 PM  23 months ago
Topic Vote0Post 1
wpoel

rrNovice

NETHERLANDS

MyPosts All Forum Topic
Fail safe setting T10CG
I want to set the fail safe for helicopter so if I power down the transmitter the motor should stop.Mandatory in our club.
I use R6008HS receiver.

Somehowe I got it working but I don't think the right way.
The throttle endpoints are set to max value (140)to get F.S.working.

Can somebody let me know the right procedure please because I think the throttle setting should be adjusted to 100% afterwards.
SHARE  PM  EMAIL  Attn:RR  Quote
12-30-2017 03:38 AM  23 months ago
BeltFedBrowning

rrKey Veteran

Kansas City

MyPosts All Forum Topic
I just went to the basic menu by holding the mode button. Open the F/S. The next page says "CH 3 THROTTLE" and below it move the cursor over "F/S". You will see a percentage in parenthesis below it(15%). You move the throttle stick where you want the failsafe and hold down the botton in the middle of the scroll knob for a few seconds to set that throttle position as failsafe.
SHARE  PM  EMAIL  GALLERY  Attn:RR  Quote
12-31-2017 07:39 PM  23 months ago
wpoel

rrNovice

NETHERLANDS

MyPosts All Forum Topic
Fail Safe
Right now I got it working however the trick to set it properly must be found.
Thank you for support.
SHARE  PM  EMAIL  Attn:RR  Quote
01-05-2018 08:40 PM  23 months ago
wpoel

rrNovice

NETHERLANDS

MyPosts All Forum Topic
Fail safe
The trick is to bind the reciever in normal mode with FS set.
This topic can be closed.
SHARE  PM  EMAIL  Attn:RR  Quote
WATCH
 1 page 437 views POST REPLY
HomeRC & Power✈️Aircraft🚁HelicopterRadio - Futaba FASST › Fail safe setting T10CG
 Print TOPIC  Make Suggestion 

 1  Topic Subscribe

Wednesday, December 11 - 10:10 pm - Copyright © 2000-2019 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online