Please Help-BeastX pitching to left

rrTV-PHOTO GALLERIES MY GALLERY HELP-FAQ

myHOME PM pmRR MEMBERS 328 ONLINE 1 EVENTS SEARCH REGISTER START HERE

WATCH

2 pages [ << < 1 ( 2 ) > >> ] 2267 views

POST REPLY

RunRyder	Scorpion Power

Home › RC & Power › ✈️Aircraft › 🚁Helicopter › Flybarless Rotor Head Systems › BeastX › Please Help-BeastX pitching to left

01-14-2017 02:04 AM 35 months ago

0Post 21

iyoy

rrVeteran

Bacolod City, Philippines

MyPosts All Forum Topic

550L

Hi guys,

I'm also a first timer with the Microbeast PLUS. I have the version 4.1.5 which came with my T-Rex 550L Dominator Super Combo. I tried to follow the manuals of Align and of Microbeast as best as I could using a standard receiver (not SBus) setup Futaba R7008SB and a T14SG. My test flight went ok. I just did normal hover just to get the feel of the heli. The head speed seemed slow and the hover was a bit wobbly with a noticeable up and down bob of the tail. After about five minutes, I decided to end the flight and just as I was about to land from a height of two feet, the heli just froze and drifted off in a bank and the blades hit the ground. Blades were wrecked and the front TT drive pinion stripped. The DFC links detached from the swashplate but this was probably caused by the impact.the battery showed 3.9v per cell after and everything seemed to be functioning when I tested after the crash. I don't have a separate receiver battery.

Any analysis to solve the problem highly appreciated. Thanks!iyoy

SHARE PM EMAIL GALLERY Attn:RR Quote

01-14-2017 02:16 PM 35 months ago

0Post 22

JuanRodriguez

rrProfessor

The Villages, Florida

MyPosts All Forum Topic

💎Sustaining Member

Rather than hijacking this thread, you might get a better response if you start a new thread of your own....Been there, done that and old enough to know better.....

SHARE PM EMAIL GALLERY Attn:RR Quote

01-14-2017 03:37 PM 35 months ago

0Post 23

iyoy

rrVeteran

Bacolod City, Philippines

MyPosts All Forum Topic

Juan Rodriguez

Sorry I didn't mean to hijack this thread. I was reading the comments and I thought by sharing a similar experience with the Microbeast Plus I could show that the occurrence of the problem is quite frequent and others, myself included could learn from the constructive comments posted here. I meant no offense to anyone.iyoy

SHARE PM EMAIL GALLERY Attn:RR Quote

01-14-2017 11:26 PM 35 months ago

0Post 24

JuanRodriguez

rrProfessor

The Villages, Florida

MyPosts All Forum Topic

💎Sustaining Member

You didn't offend anyone.....

My comment was constructive in nature..... I believe that you would get a better response by starting your own "fresh" thread.......Been there, done that and old enough to know better.....

SHARE PM EMAIL GALLERY Attn:RR Quote

03-01-2017 01:39 AM 34 months ago

0Post 25

AgentOrange

rrVeteran

Jacksonville, Florida

MyPosts All Forum Topic

I am having the same issue as the OP. My heli has been stored away for little over a year and started it up and hovered it and it seemed fine then I did some collective pumps and when I stopped it rolled to the left. I recovered it and landed it. Redid the setup again and flew it with the same problem. Redid the setup a third time with the same results. My heli did not crash as I was high enough to recover and hit throttle hold and land it safely. I am going to replace my tape and try again tomorrow. Also I have mine strapped down would that make any difference at all.Trying not to put them in the dirt.

SHARE PM EMAIL GALLERY Attn:RR Quote

03-01-2017 03:52 PM 33 months ago

0Post 26

Richardmid1

rrProfessor

Leeds, England

MyPosts All Forum Topic

I am going to replace my tape and try again tomorrow. Also I have mine strapped down would that make any difference at all.

Yes replace the tape if it's a nitro with old tape. Don't use the thick white pad though, just one piece of the thin 3M grey pad and no need to strap it down. Strapping down gyros can make things worse.60% of the time, it works every time!

SHARE PM EMAIL HOMEPAGE GALLERY Attn:RR Quote

03-01-2017 09:57 PM 33 months ago

0Post 27

AgentOrange

rrVeteran

Jacksonville, Florida

MyPosts All Forum Topic

Well just wanted to report that I did replace my tape and heli flies like a champ. No issues any more. Flew a whole tank with no issues so thanks for the help. To the OP I hope you get yours figured out.Trying not to put them in the dirt.

SHARE PM EMAIL GALLERY Attn:RR Quote

WATCH

2 pages [ << < 1 ( 2 ) > >> ] 2267 views

POST REPLY

RunRyder	Scorpion Power

Home › RC & Power › ✈️Aircraft › 🚁Helicopter › Flybarless Rotor Head Systems › BeastX › Please Help-BeastX pitching to left

Print TOPIC

Make Suggestion

9 Topic Subscribe

New Subscriptions

Buddies Online