RunRyder RC
WATCH
 1 page 1610 views Post Reply
07-04-2016 03:31 AM  4 years ago
Topic Vote0Post 1
Tom French

rrNovice

Heathrow Florida

MyPosts All Forum Topic
Navigation lites
I have Vortex how do I connect my switch on to the R3.?

thanks
Goblin 700
Goblin 570
SHARE  PM  EMAIL  Attn:RR  Quote
07-05-2016 02:26 PM  4 years ago
Eury

rrProfessor

Dover NH USA

MyPosts All Forum Topic
💎Sustaining Member
Your question doesn't have much detail, so it's tough to say for sure what you're looking for. I'm going to assume you are running a heli with the Vortex FBL and an R3 running UDI since Spartan said you need a REX receiver to run EX bus with the Vortex.

If that's the case, and you have lights with a controller, just plug the controller into port 1 or 2 on your R3. Then in your Jeti, setup a channel for the lights (let's say channel 8 for this discussion) and map it to a switch. Now go into Device Explorer, Receiver Outputs, and change the value of the port you plugged your lights into so it is sending out Channel 8 for your lights.

That's it. Easy.
Nick Crego

Citizen #0168
SHARE  PM  EMAIL  GALLERY  Attn:RR  Quote
07-06-2016 07:32 PM  4 years ago
Tom French

rrNovice

Heathrow Florida

MyPosts All Forum Topic
Thanks for the info, willl try this week.Goblin 700
Goblin 570
SHARE  PM  EMAIL  Attn:RR  Quote
WATCH
 1 page 1610 views Post Reply
Print TOPIC

 2  Topic Subscribe

Monday, September 21 - 8:43 pm - Copyright © 2000-2020 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online