RunRyder RC
WATCH
 1 page 774 views POST REPLY
HomeAircraftMulti-Rotor
e-
FPV Racing
› DX8 and R9D Binding?
12-01-2015 03:03 AM  32 months agoPost 1
21chip21

rrApprentice

waterford

My Posts: All  Forum  Topic

Trying to setup and bind DX8 and R9D Receiver for Kylin 250 Quadcopter. Tried using bind plug in Receiver. There is a little button on side of receiver and one person said I need to hit button twice to make light red. Then turning on radio with holding bind button on radio. That does not work either. Anyone have a insight?
Quad uses OpenPilot on board. tried using setup wizard and it does not see the radio.
Help...

Furry Tempest,T-Rex, Raptor 50,Gy601,GV1,Radio 9Z,JR XP8103,Muscle II pipe,Coolpower 30%

PM  EMAIL  GALLERY  Attn:RR  Quote
12-02-2015 08:12 PM  31 months agoPost 2
steph

rrKey Veteran

Hampshire England

My Posts: All  Forum  Topic

I have not used this tx or rx but doing a little research came up with this

1.Place the transmitter and the receiver close to each other within one(1)meter.
2.Turn on the transmitter.
3. Press and hold ID SET switch of the receiver one second, now the indicator LED will start blinking.
It will automatically find the nearest transmitter to bind,
which is an outstanding feature for R9D receiver.
4.Test with servo to make sure the binding is finished

http://www.skyhobbies.com.sg/Radiol.../AT9_Manual.pdf

Hope this helps

The world is round you can run but you will always end up where you started from

PM  EMAIL  GALLERY  Attn:RR  Quote
WATCH
 1 page 774 views POST REPLY
HomeAircraftMulti-Rotor
e-
FPV Racing
› DX8 and R9D Binding?
 Print TOPIC  Make Suggestion 

 2  Topic Subscribe

Wednesday, July 18 - 11:36 pm - Copyright © 2000-2018 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online