RunRyder RC
WATCH
 1 page 661 views POST REPLY
HomeAircraftHelicopterHIROBOHirobo Turbulence › SSZ-IV Centre Pin
09-05-2015 11:39 PM  3 years agoPost 1
PaulBowen

rrKey Veteran

Victoria, Australia.

My Posts: All  Forum  Topic

Hello,

Just wondering the consensus on the installation of the grub screw securing the centre pin to the spindle. This is on the flybarless head on the Turbulence D3v2 but would also apply to other Hirobo models. I have noticed that with the grub screw installed the spindle is about 0.5mm offset to one side.

So the question is to grub screw or not to grub screw? Does it make a difference and if so what?

PM  EMAIL  GALLERY  Attn:RR  Quote
09-06-2015 01:36 AM  3 years agoPost 2
TMoore

rrMaster

Cookeville, TN

My Posts: All  Forum  Topic

I've run them both ways, doesn't make much difference.

Delayed Response Operator Not Engaged
AMA SECTION 336 = Good
Drones = EVIL

PM  EMAIL  HOMEPAGE  GALLERY  Attn:RR  Quote
09-07-2015 03:13 PM  3 years agoPost 3
Dr.Ben

rrMaster

Richmond, VA, USA

My Posts: All  Forum  Topic

+1
The center teeter does very little in a head with dampening as stiff as the stock IV has. I always pulled mine because a little axle lead-lag is not a bad thing, especially at lower head speeds.

NOW, if dampening is softer and the head is built in a trailing pitch arm configuration, the the center teeter becomes quite necessary.

Ben Minor

Peak Aircraft/Team Minicopter Team Futaba Team Kontronik USA

PM  EMAIL  GALLERY  Attn:RR  Quote
09-07-2015 08:24 PM  3 years agoPost 4
PaulBowen

rrKey Veteran

Victoria, Australia.

My Posts: All  Forum  Topic

Thanks guys I was considering removing the grub srew to allow the spindle to find it's own natural centre position. I am running softer damping on this head. It is the flybarless version.

PM  EMAIL  GALLERY  Attn:RR  Quote
WATCH
 1 page 661 views POST REPLY
HomeAircraftHelicopterHIROBOHirobo Turbulence › SSZ-IV Centre Pin
 Print TOPIC  Make Suggestion 

 2  Topic Subscribe

Friday, September 21 - 8:57 pm - Copyright © 2000-2018 RunRyder   EMAILEnable Cookies

The RC discussion world needs to consolidate. RR is now one choice for that. Its software is cutting edge. It hosts on-topic advertising. Help RR increase traffic buy making suggestions, posting in RR's new areas (sites) and by spreading the word.

The RunRyder Difference

• Category system to allow Rep/Vendor postings.
• Classifieds with sold (hidden) category.
• Classifieds with separate view new.
• Answer PMs offsite via email reply.
• Member gallery photos with advanced scripting.
• Gallery photo viewer integrated into postings.
• Highly refined search with advanced back end.
• Hosts its own high end fast response servers.
• Hosts thousands of HD event coverage videos.
• Rewrote entire code base with latest technology.
• No off-topic (annoying) click bait advertising.
Login Here
 New Subscriptions 
 Buddies Online