RunRyder RC
WATCH
 1 page 944 views Topic Closed
Home✈️Aircraft🚁Helicoptere-Synergy R/CSynergy E5 › E5 pre assembled main gear
05-07-2015 04:22 PM  6 years ago
Topic Vote0Post 1
gcm2

rrApprentice

Ft Worth, TX

MyPosts All Forum Topic
E5 pre assembled main gear
Building an E5. Coming along nicely. The videos on youtube are very helpful. No issues except the little set screw into the tail output shaft to hold in the that pressed in cross pin was missing in my kit. I had a spare to use.

Q: Do I need to take apart the main gear assembly and grease/oil the one way bearing? I did not, and do not want to.

Thank you.
TREX 700e, Goblins 500 & 570, DT520e, Gaui X3, Synergy E5
SHARE  PM  EMAIL  Attn:RR
05-07-2015 04:31 PM  6 years ago
Chris Sexton

rrApprentice

Columbus, OH

MyPosts All Forum Topic
Hello!

Yes you need to loctite the small cap screws holding the auto gear on. As well as loctite the bronze bushing on the auto Hub in place. If you don't these can bind on the main shaft.
Chris Sexton
Synergy Factory Specialist / Team Scorpion
SHARE  PM  EMAIL  GALLERY  Attn:RR
05-07-2015 04:37 PM  6 years ago
gcm2

rrApprentice

Ft Worth, TX

MyPosts All Forum Topic
Thanks Chris, will do. Your videos (pretty sure it's you) are excellent. So the one way is already oiled?TREX 700e, Goblins 500 & 570, DT520e, Gaui X3, Synergy E5
SHARE  PM  EMAIL  Attn:RR
05-07-2015 07:24 PM  6 years ago
gcm2

rrApprentice

Ft Worth, TX

MyPosts All Forum Topic
OK, I've done everything as manual states, like I should have before asking! A little Triflow in the one way. Closing thread.TREX 700e, Goblins 500 & 570, DT520e, Gaui X3, Synergy E5
SHARE  PM  EMAIL  Attn:RR
WATCH
 1 page 944 views Topic Closed
Home✈️Aircraft🚁Helicoptere-Synergy R/CSynergy E5 › E5 pre assembled main gear
Print TOPIC

 0  Topic Subscribe

Monday, July 26 - 3:10 pm - Copyright © 2000-2021 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online