thanksAnother issue I have run in to
Here is my setup
One R3 receiver connected to Control box on R1 port.
Beastx was setup with R11 receiver but I could not ignore the added advantages of a control box. After I was able to see control box in Tx screen, I attached the Ch1,2,3,4 ,5,6 servo connections from Beastx to Control box port (exactly same as they were on RX11). Now all the cyclic controls are messed up which were perfectly working with R11 receiver
These are hitec servos and were setup for 200 hz on beastx . What am I doing wrong ?
Garden State, NJ