RunRyder RC
WATCH
 1 page 761 views POST REPLY
HomeAircraftHelicopterHelicopter Main Discussion › logo 600 700mx 510v motor 600blades
03-14-2015 09:54 PM  3 years agoPost 1
billyboy

rrNovice

greeneville tennessee us

My Posts: All  Forum  Topic

Whats the best pinion for 1700 and 1800 headspead

Which pinion would be best 11t or 12t

Cc edge 80hv and 3300 mah packs 12s

PM  EMAIL  Attn:RR  Quote
03-14-2015 11:31 PM  3 years agoPost 2
Fauropitotto

rrApprentice

Tampa, FL

My Posts: All  Forum  Topic

You can use this calculator here to find out:

http://www.dhrc.rchomepage.com/calcAdvanced.htm

Some ESCs need to run at a high percentage, so you'll need to read your manual to find out what is best.

PM  EMAIL  GALLERY  Attn:RR  Quote
03-15-2015 12:26 AM  3 years agoPost 3
Trexwilly

rrVeteran

FL USA

My Posts: All  Forum  Topic

Yup depends on your ESC, and the flight pack 10S is going to need taller pinion, 12S not so much...

PM  EMAIL  GALLERY  Attn:RR  Quote
03-15-2015 10:29 PM  3 years agoPost 4
Andy from Sandy

rrElite Veteran

Bedfordshire, UK

My Posts: All  Forum  Topic

As a direct answer the 11T will be best but for a 12S setup a 450Kv motor would be better.

PM  EMAIL  GALLERY  Attn:RR  Quote
03-16-2015 02:42 AM  3 years agoPost 5
KC

rrElite Veteran

WA

My Posts: All  Forum  Topic

Billyboy, try the 10t mod 1.0 pinion first.

It will run just over 2000rpm with the Castle (120?) and 700mx.

I'm not sure why you want 17-1800rpm, but check this out...

This is a small motor in a Logo 600 at 2000rpm:

Watch at YouTube

That heli was 8lbs, yours is 9lbs.

The big motors are dead-weight until 22-2300rpm, theyre good for spinning those rpms.

You could fly a Logo 600 on just one of your 6s 3300mah packs and fly with a 4025-890 scorpion motor....not joking.

The flying weight would be around 7 lbs. It will fly about half as hard as that video on a 3300mah and go through those packs in a few months. BUT the same motor with a 5000mah battery would outperform that video and the packs would last a while.

(that setup in the video was an actor 24-3 with a 4000mah 10s pack. It is 11 ounces heavier than a 6s 4500mah Logo 600)

I'm building a 7 lb 10s Logo 550se at the moment

PM  EMAIL  GALLERY  Attn:RR  Quote
03-16-2015 03:19 AM  3 years agoPost 6
billyboy

rrNovice

greeneville tennessee us

My Posts: All  Forum  Topic

trying a 470 kv 700mx and 11t pinion
Im just enjoying sport flying and mild 3d anybody think this would be good for low head flying

PM  EMAIL  Attn:RR  Quote
WATCH
 1 page 761 views POST REPLY
HomeAircraftHelicopterHelicopter Main Discussion › logo 600 700mx 510v motor 600blades
03-16-2015 04:11 AM  3 years ago •• Post 7 ••
KC

rrElite Veteran

WA

My Posts: All  Forum  Topic

That or the 510kv with the 10t pinion will be great for sport and mild 3d.

Do you have either 700mx motor at the moment?

PM  EMAIL  GALLERY  Attn:RR  Quote
03-16-2015 04:21 AM  3 years agoPost 8
billyboy

rrNovice

greeneville tennessee us

My Posts: All  Forum  Topic

trying a 470 kv 700mx and 11t pinion
I have a 700mx 510kv and 12t pinion on it now got a deeal on a 700mx 470kv and 11t pinion on the way see which combo I like best

PM  EMAIL  Attn:RR  Quote
03-16-2015 05:05 AM  3 years agoPost 9
KC

rrElite Veteran

WA

My Posts: All  Forum  Topic

Gotcha

sounds like you tried the higher rpms then...

Try the 10t pinion too.

PM  EMAIL  GALLERY  Attn:RR  Quote
03-16-2015 11:30 PM  3 years agoPost 10
Andy from Sandy

rrElite Veteran

Bedfordshire, UK

My Posts: All  Forum  Topic

Are you sure Mikado make a 10T mod 1 pinion for a 6mm shaft?

I don't think there is enough metal at the centre for one.

PM  EMAIL  GALLERY  Attn:RR  Quote
03-17-2015 03:15 AM  3 years agoPost 11
billyboy

rrNovice

greeneville tennessee us

My Posts: All  Forum  Topic

mikado pinion
Mikado dont make a 10t pinion in 6mm as far as I know

PM  EMAIL  Attn:RR  Quote
03-17-2015 03:29 AM  3 years agoPost 12
KC

rrElite Veteran

WA

My Posts: All  Forum  Topic

I must have been smoking something guys...4 years ago I could swear they had a 10t mod 1 (didn't think about whether it was 5 or 6mm)

I can't find it on the US or German site.

disregard the 10t!

PM  EMAIL  GALLERY  Attn:RR  Quote
WATCH
 1 page 761 views POST REPLY
HomeAircraftHelicopterHelicopter Main Discussion › logo 600 700mx 510v motor 600blades
 Print TOPIC  Make Suggestion 

 2  Topic Subscribe

Friday, September 21 - 12:46 pm - Copyright © 2000-2018 RunRyder   EMAILEnable Cookies

The RC discussion world needs to consolidate. RR is now one choice for that. Its software is cutting edge. It hosts on-topic advertising. Help RR increase traffic buy making suggestions, posting in RR's new areas (sites) and by spreading the word.

The RunRyder Difference

• Category system to allow Rep/Vendor postings.
• Classifieds with sold (hidden) category.
• Classifieds with separate view new.
• Answer PMs offsite via email reply.
• Member gallery photos with advanced scripting.
• Gallery photo viewer integrated into postings.
• Highly refined search with advanced back end.
• Hosts its own high end fast response servers.
• Hosts thousands of HD event coverage videos.
• Rewrote entire code base with latest technology.
• No off-topic (annoying) click bait advertising.
Login Here
 New Subscriptions 
 Buddies Online