RunRyder RC
WATCH
 1 page 586 views POST REPLY
HomeAircraftHelicopterMain Discussion › Microbeast v2 tail barely moves
03-10-2015 04:52 PM  3 years agoPost 1
Uglysteve

rrNovice

Spring, TX USA

My Posts: All  Forum  Topic

Hello,

It's probably a newb mistake, but after I'be setup my Microbeast on my Align 450, the tail will barely move at all with rudder stick input.

I setup all the limits to the maximum rudder travel. When in step F, the tail moves a great deal and has correct sensor direction. But when i'm out of the setup menu, it barely moves at all.

I'm using a DX9 and the tail servo is a futaba s9257. I setup the frequency at 333hz and the Center pulse at 1520.

please help.

PM  EMAIL  Attn:RR  Quote
03-10-2015 05:12 PM  3 years agoPost 2
RAK402

rrElite Veteran

Alhambra, CA

My Posts: All  Forum  Topic

I have done this (twice).

In both cases, I failed to link the Gyro gain channel to the Flight Mode switch on the 11X. Once I did that, I got full throw.

I think it has to do with the BeastX not seeing a signal from the Gyro Gain channel (been a long time since I did it).

I have read about this happening with a variety of radios.

Team KBDD/Compass Team Manger/Experience RC/Team JR Americas/WR Field Rep

PM  EMAIL  GALLERY  Attn:RR  Quote
03-10-2015 05:36 PM  3 years agoPost 3
funkindatrunk

rrApprentice

Millersville TN USA

My Posts: All  Forum  Topic

If you have a dx9 (same as I use) go into gyro menu and make sure gyro is on or assin to a switch. I just turn mine on and set value.

I have learned if you move the sticks the right way you wont crash.

PM  EMAIL  GALLERY  Attn:RR  Quote
03-30-2015 02:48 AM  3 years agoPost 4
Uglysteve

rrNovice

Spring, TX USA

My Posts: All  Forum  Topic

You were right. I needed to setup the gyro in the TX. total Noob mistake.

PM  EMAIL  Attn:RR  Quote
03-30-2015 03:04 AM  3 years agoPost 5
Jerry K

rrKey Veteran

Houston Area

My Posts: All  Forum  Topic

Boot up the MB and right after it boots a light will come on for about 10s. This is your gyro gain, it sounds like your gain is set to low. You will want the 'F - G' light to come on. This will be set on Ch5 which should be set to 'gyro' in the tx Somewhere around 35-40% gyro gain depending on which transmitter you have.

PM  EMAIL  GALLERY  Attn:RR  Quote
WATCH
 1 page 586 views POST REPLY
HomeAircraftHelicopterMain Discussion › Microbeast v2 tail barely moves
 Print TOPIC  Make Suggestion 

 2  Topic Subscribe

Wednesday, August 22 - 4:30 am - Copyright © 2000-2018 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online