RunRyder RC
 2  Topic Subscribe
WATCH
 1 page 576 views POST REPLY
HomeAircraftHelicopterMain Discussion › KDS Flymentor 3D
10-25-2014 05:10 PM  3 years agoPost 1
jtdesert

rrNovice

Kremmling CO USA

My Posts: All  Forum  Topic

Recently purchased Flymentor,read manual,watched video's on setup etc. but can't get controller to turn green checked & re checked wires using Spektrum AR6200 receiver & Dx61 radio. Do I need to purchased different receiver for this to work? Any suggestions, ideas, appreciated. Thanks

PM  EMAIL  Attn:RR  Quote
10-26-2014 03:56 AM  3 years agoPost 2
wc_wickedclown (RIP)

rrProfessor

long beach calif

My Posts: All  Forum  Topic

jtdesert
Recently purchased Flymentor,read manual,watched video's on setup etc. but can't get controller to turn green checked & re checked wires using Spektrum AR6200 receiver & Dx61 radio. Do I need to purchased different receiver for this to work? Any suggestions, ideas, appreciated. Thanks
you need a 7 ch tx

Insha Allah made in america

PM  EMAIL  HOMEPAGE  GALLERY  Attn:RR  Quote
10-26-2014 04:27 AM  3 years agoPost 3
altima1779

rrKey Veteran

Toledo, oh u.s

My Posts: All  Forum  Topic

What color light are you seeing? The video I watched showed setting it up on a dx6i so you should be fine with the equipment you have.

PM  EMAIL  HOMEPAGE  GALLERY  Attn:RR  Quote
10-26-2014 05:04 AM  3 years agoPost 4
wc_wickedclown (RIP)

rrProfessor

long beach calif

My Posts: All  Forum  Topic

altima1779
What color light are you seeing? The video I watched showed setting it up on a dx6i so you should be fine with the equipment you have.
i guess your correct

You need a 7 channel Rx to switch between ON/Off....position mode....balance mode.

If you have a 6 channel Rx you can switch between position and balance modes.

Insha Allah made in america

PM  EMAIL  HOMEPAGE  GALLERY  Attn:RR  Quote
10-26-2014 02:59 PM  3 years agoPost 5
jtdesert

rrNovice

Kremmling CO USA

My Posts: All  Forum  Topic

Red blinking light
Keep getting red blinking light and instructions say no power from receiver to KDS controller. I disconnected everything involving this KDS and re wired receiver,gyro,edit TX etc.and everything runs fine. Still lost on why it didn't initialize and turn to green light.

PM  EMAIL  Attn:RR  Quote
WATCH
 1 page 576 views POST REPLY
HomeAircraftHelicopterMain Discussion › KDS Flymentor 3D
 Print TOPIC  Make Suggestion 

 2  Topic Subscribe

Monday, June 25 - 4:57 pm - Copyright © 2000-2018 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online