RunRyder RC
 1  Topic Subscribe
WATCH
 1 page 373 views POST REPLY
HomeAircraftHelicopterMain Discussion › mah converted to volts on t1100 telemetry module
06-25-2014 05:17 PM  4 years agoPost 1
tomtek

rrApprentice

ga

My Posts: All  Forum  Topic

OK, I am not able to get the t1100 to show me the mah either remaining or used while flying. Is there a way to convert mah to volts so when I am seeing how much voltage, while flying, I have remaining I can figure out what the mah is?

PM  EMAIL  GALLERY  Attn:RR  Quote
06-25-2014 06:58 PM  4 years agoPost 2
Red B.

rrNovice

Jonkoping, Sweden

My Posts: All  Forum  Topic

No,you will not be able to get anything but a very approximate charge state (mAh) from a voltage reading. Charge and voltage are different physical quantities and for LiPo batteries there is a non-linear relationship between the two that also depends on the current draw. The graph below serves as an example.

PM  EMAIL  GALLERY  Attn:RR  Quote
06-25-2014 10:37 PM  3 years agoPost 3
Heli_Splatter

rrElite Veteran

USA

My Posts: All  Forum  Topic

Am I missing something.
I don't get the OP's question... why not do like everyone else and land when the per cell voltage drops below 3.6 volts per cell.

The mahr charge count is really meaningless to me. It is not accurate charging or discharging. Don't tell me that you really believe those numbers on the charger. (BTW I use iChargers and think that they are pretty good)

The only thing that I care about is volts/cell. Even that is dependent on loading such as climbing or descending work load.

PM  EMAIL  GALLERY  Attn:RR  Quote
WATCH
 1 page 373 views POST REPLY
HomeAircraftHelicopterMain Discussion › mah converted to volts on t1100 telemetry module
 Print TOPIC  Make Suggestion 

 1  Topic Subscribe

Sunday, June 24 - 7:55 pm - Copyright © 2000-2018 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online