RunRyder RC
WATCH
 1 page 622 views POST REPLY
HomeAircraftHelicopterRadio - Spektrum DSM › programming problem. dx18,dx18QQ and 7s
06-03-2014 02:35 AM  4 years agoPost 1
jongam0

rrApprentice

ft. wayne, in usa

My Posts: All  Forum  Topic

i have programmed a heli on each one of these radios(vbar and CC). the problem i have is when i try to set throttle end points on my castle ESC, the ESC will not recognize the trim of the radio to set the endpoints. but i went to a different model and everything worked flawless. horizon said they have not heard anything of this before. also the models used in each radio had been either new or reset to default settings before i started.

any thoughts?

earth ----- my worst obstical

PM  EMAIL  GALLERY  Attn:RR  Quote
06-03-2014 03:35 AM  4 years agoPost 2
aerocal

rrApprentice

Central California

My Posts: All  Forum  Topic

I dont have a CC so its not fresh in my mind but IIRC there is a procedure for getting the endpoints right.Ill try to remeber where I saw that and do a couple searches.

PM  EMAIL  GALLERY  Attn:RR  Quote
06-03-2014 10:16 AM  4 years agoPost 3
jongam0

rrApprentice

ft. wayne, in usa

My Posts: All  Forum  Topic

i know how to do the endpoints. i just want to know why it sets up fine on some models in the radio and not on others.

earth ----- my worst obstical

PM  EMAIL  GALLERY  Attn:RR  Quote
WATCH
 1 page 622 views POST REPLY
HomeAircraftHelicopterRadio - Spektrum DSM › programming problem. dx18,dx18QQ and 7s
 Print TOPIC  Make Suggestion 

 1  Topic Subscribe

Tuesday, July 17 - 10:36 pm - Copyright © 2000-2018 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online