RunRyder RC
WATCH
 2 pages [ <<    <     1     ( 2 )    >    >> ] 1422 views Post Reply
Home✈️Aircraft🚁HelicopterHelicopter Main Discussion › engine inspection YS 60SR
04-28-2014 04:28 AM  6 years ago
hyflyr

rrApprentice

Baton Rouge, LA

MyPosts All Forum Topic
I would not heat the clutch significantly to remove the bearing. Press it out and press in a new one. Something must have been out of alignment to damage the bearing. I have tons of time on many machines and even had clutches blow up due to the engine going to wide open on crashes and not had the start bearing go out. I even use a dynatron starter on lipo power and not hurt a clutch bearing. I would take a good look at your setup to see what killed that bearing.Scott
SHARE  PM  EMAIL  GALLERY  Attn:RR  Quote
04-28-2014 04:51 AM  6 years ago
joecass

rrVeteran

NJ

MyPosts All Forum Topic
it's been slipping all winter for some reason. I new it was just a mater of time till it would blow apart
SHARE  PM  EMAIL  GALLERY  Attn:RR  Quote
WATCH
 2 pages [ <<    <     1     ( 2 )    >    >> ] 1422 views Post Reply
Home✈️Aircraft🚁HelicopterHelicopter Main Discussion › engine inspection YS 60SR
Print TOPIC

 6  Topic Subscribe

Wednesday, October 28 - 2:46 pm - Copyright © 2000-2020 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online