They are just not anywhere in the kit.
Can I substitute a standard small washer "safely"?
Also, the documentation sheet on the E360 mod tells me to replace the brand new head dampers and reverse the position of the thrust bearings and the outer grip bearings to avoid boom strikes.
Anyone got experience/wisdom to share on this?

Wayne

I love the smell of nitro in the morning.
RIP Roman

Wayne

Those safety washers are flat on one side and has a raised area that goes against the inner race of the radial bearing.
I would e-mail helihotline@hobbico.com to get the washers. I've had GD luck dealing with them, other option would be buying the PV0781 screw bag.

Thank you sir.
I will send that E-mail.

Wayne

I love the smell of nitro in the morning.
RIP Roman

Is it the washers in here?
http://www3.towerhobbies.com/cgi-bi...p?&I=LXAGPD&P=7
or here?
http://www3.towerhobbies.com/cgi-bi...p?&I=LXAGLW&P=Z

Gary Wright

It is in the PV0781.

I just spoke with Hobbico and they are sending the part out to me.
Thank you very much for your reply......and Thank You Hobbico!

Wayne

I love the smell of nitro in the morning.
RIP Roman

nevermind on the last one, It didn't click that the blade grip one was for a V1. I think support sent you out the screw bag already.

Gary Wright

Thanks again gwright.
You guys are awesome.

Wayne

I love the smell of nitro in the morning.
RIP Roman

By the way, I will be ordering a G4.1 Nitro Friday.
Tower support is excellent.

Wayne

I love the smell of nitro in the morning.
RIP Roman