I had set my Kosmic BEC to 6.6V to drive my 272 servos. Personally I don't notice any difference between now and before at 5.6V. Would you like to share your experience?
I have same question as well about the parameters available in 272. Just don't know where to start, e.g. when gear slop developed in my 272, by how much should I lower the dead band of the servo to compensate the slop? or just replace the servo.
Another one is that if I have a plank servo, e.g. BLS175SV, what parameters can be changed to make it close to a BLS272SV in terms of centering feel? I know the torque and speed can not be changed.