RunRyder RC
WATCH
 1 page 2100 views POST REPLY
HomeRC & Power✈️Aircraft🚁HelicopterRadio - Futaba FASST › 14SG Throttle Cut
12-13-2013 03:28 AM  5 years ago
Topic Vote0Post 1
rwilabee

rrApprentice

La Quinta, CA

MyPosts All Forum Topic
14SG Throttle Cut
I am having a problem getting the Throttle Cut to work. I have gone into THR Cut and at ACT I changed it to Off which was my only choice beside INH. I picked switch SB and then went and made the top of the switch Off and the bottom On. No matter what percentage I put for POS the carb doesn't move. When I turn the switch on should the ACT change from OFF to On? I can't figure out what I am doing wrong.
SHARE  PM  EMAIL  GALLERY  Attn:RR  Quote
12-13-2013 07:57 PM  5 years ago
Andy from Sandy

rrElite Veteran

Bedfordshire, UK

MyPosts All Forum Topic
First off have you set a value above which it won't do anything? This is so if the throttle stick is up you can't accidentally cut the engine.

On my setup I only have it enabled when in normal mode so again it won't do anything if I am in another flight mode.

So I have NORMAL = ACT, POS = 7%, SW = H and THRO = 3%.

At the top of the THR CUT screen it shows flight mode NORMAL and OFF. When I flick switch H it shows as ON.

When you are on the THR CUT screen there is a slider picture at the right hand side. Where is the black triangle to the left and where is the white triangle to the right?
SHARE  PM  EMAIL  GALLERY  Attn:RR  Quote
12-14-2013 01:26 AM  5 years ago
rwilabee

rrApprentice

La Quinta, CA

MyPosts All Forum Topic
Is it ok to set the idle with the throttle trim first.
SHARE  PM  EMAIL  GALLERY  Attn:RR  Quote
12-14-2013 04:50 PM  5 years ago
Andy from Sandy

rrElite Veteran

Bedfordshire, UK

MyPosts All Forum Topic
I don't think the trim makes any difference to where the setting for throttle cut is.

I always adjust either the lowest point in the throttle curce menu or use the servo travel adjust to set the tickover. I can then use the trim for those rare occasions where I want a slightly faster idle.
SHARE  PM  EMAIL  GALLERY  Attn:RR  Quote
12-15-2013 12:59 AM  5 years ago
rwilabee

rrApprentice

La Quinta, CA

MyPosts All Forum Topic
I finally got it to work. I had to make a new model and then set up my servo directions, etc. Something happened in the original model but I couldn't see what it was.
SHARE  PM  EMAIL  GALLERY  Attn:RR  Quote
WATCH
 1 page 2100 views POST REPLY
HomeRC & Power✈️Aircraft🚁HelicopterRadio - Futaba FASST › 14SG Throttle Cut
 Print TOPIC  Make Suggestion 

 1  Topic Subscribe

Tuesday, October 15 - 8:44 am - Copyright © 2000-2019 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online