RunRyder RC
WATCH
 1 page 804 views POST REPLY
Home✈️Aircraft🚁HelicopterBlades and Night Flying › Sanding down tail blade root to fit in grip
10-31-2013 07:44 PM  5 years ago
Topic Vote0Post 1
volito

rrNovice

Jax, FL

MyPosts All Forum Topic
Sanding down tail blade root to fit in grip
I ordered a set of Edge 92mm tail blades to put on my trex 550, one of them fit's perfectly but the other is too wide at the root(tried it in both tail grips, hard to fit in each)

The root is 8 thousandths of an inch wider than the other blade, any harm in sanding it down to fit? They aren't b surface blades so not sure what's up with the inconsistency.
SHARE  PM  EMAIL  GALLERY  Attn:RR  Quote
10-31-2013 07:57 PM  5 years ago
DemetriusUSN

rrVeteran

Virginia Beach, Va USA

MyPosts All Forum Topic
No harm, just be very careful and don't sand too much. Just enough tp give it a snug fit.Minicopter Diabolo 800, Minicopter Triabolo 700, Minicopter Diabolo 700, Minicopter Diabolo 600, Minicopter Diabolo 550, Goblin 770
SHARE  PM  EMAIL  HOMEPAGE  GALLERY  Attn:RR  Quote
10-31-2013 08:12 PM  5 years ago
volito

rrNovice

Jax, FL

MyPosts All Forum Topic
Awesome, thanks
SHARE  PM  EMAIL  GALLERY  Attn:RR  Quote
WATCH
 1 page 804 views POST REPLY
Home✈️Aircraft🚁HelicopterBlades and Night Flying › Sanding down tail blade root to fit in grip
 Print TOPIC  Make Suggestion 

 1  Topic Subscribe

Saturday, July 20 - 4:05 am - Copyright © 2000-2019 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online