Ok, I am having an issue and need help. I have been out of the "game" for a year and building a new heli to get back in. But setting up a throttle servo is giving me trouble LOL!!! TX is a 14SG. I am setting up my throttle servo on the bench and having the following issue:
ATV's are set at 135 and end points are set at 100 for the throttle channel and throttle trim is centered. With those settings, I adjust my servo arm length and throttle arm length and I can get full travel of throttle fully closed and throttle fully open. Now, if I adjust the throttle trim on the TX to a position I believe will provide a good idle (approximately -25 on the trim), when I go to full throttle, the servo is over driven (the servo wants to travel farther than the throttle will allow - it binds). Basically adding trim extends the end point.
How do I account for that? I am sure the answer is super simple and amazingly easy, but the solution evades me LOL!
How can I setup full throttle travel (fully closed to fully open) and still be able to adjust the trim for idle once I get the field and am able to start the engine and adjust the idle without it effecting the full throttle end point and over-driving the servo?
FYI, I also setup throttle cut on switch SH if that matters.
Thanks in advance!