RunRyder RC
WATCH |
1 page 909 views | Post Reply |
| RunRyder | RunRyder |
|
|
0| totally_awesome
rrApprentice Fredericksburg, Virginia |
Accucell 8150 - Input volume error Hello, I am getting the following error message on a Accucell 8150 charger "Input Volume error". The description of the error from the manual is as followsThe voltage of input power drops below the limit.
The voltage of Lithium battery pack was selected incorrectly. Verify the voltage of battery pack care fully. The error message above implies that the dc power supply cannot provide enough power to the charger. So do I need a bigger power supply?Here is some more information about my charging configuration.-DC Power Supply - Chargery A30 (350 watts 14volts at 25 amps)-Turnigy 8150 charger (150 watts, 7 amps max) parallel charge board with two 6S 2650 Lipos (charger set to 5.3 AMP for a 6s balance charge) I have two of these chargers connected to the power supply above. So the power supply needs to produce at least 10.6 amps which is well below the spec value of 24 for the power supply. An ideas what is going on? |
| SHARE PM EMAIL Attn:RR Quote | |
WATCH |
1 page 909 views | Post Reply |
| RunRyder | RunRyder |
|
|
Wednesday, January 20 - 4:09 pm - Copyright © 2000-2021 RunRyder EMAIL • Enable Cookies
