RunRyder RC
WATCH
 1 page 525 views POST REPLY
Home✈️Aircraft🚁HelicopterBeginners Corner › bec/esc question
05-11-2013 02:35 PM  6 years ago
Topic Vote0Post 1
othrbro

rrNovice

McCalla, AL-USA

MyPosts All Forum Topic
bec/esc question
When hooking up ESC to ar6210 rec, does the bec wires(red/black) go into the throttle slot, if so, which slot so the ESC (3 wires) connect
. This is a hobby wing 60A pentium
SHARE  PM  EMAIL  GALLERY  Attn:RR  Quote
05-11-2013 02:50 PM  6 years ago
Heli 770

rrProfessor

USA.

MyPosts All Forum Topic
Are you using an external BEC with the ESC? If, yes ESC to throttle and use a "Y" harness on any port to plug in the BEC for power.
SHARE  PM  EMAIL  Attn:RR  Quote
05-11-2013 09:32 PM  6 years ago
RCHSF

rrKey Veteran

NC

MyPosts All Forum Topic
Be sure to unplug the hot wire on the ESC, from inside the connector. If useing a seperate bec.

And you can plug the bec into any other unused port.
SHARE  PM  EMAIL  Attn:RR  Quote
05-12-2013 04:14 AM  6 years ago
dkshema

rrMaster

Cedar Rapids, IA

MyPosts All Forum Topic
If you are using the ESC and its built-in BEC to power the electronics, then simply plug the ESC three-wire cable directly into the receiver throttle channel. It will provide power to the radio and servos as well as receive throttle commands to control the motor speed.

If you are using a separate regulator to power your electronics, then the output of the separate regulator would plug into the RX battery port, you would remove the center (red) wire from the ESC three-wire plug, and still plug that connector into the RX throttle channel.
-----
Dave

* Making the World Better -- One Helicopter at a time! *

Team Heliproz
SHARE  PM  EMAIL  GALLERY  Attn:RR  Quote
WATCH
 1 page 525 views POST REPLY
Home✈️Aircraft🚁HelicopterBeginners Corner › bec/esc question
 Print TOPIC  Make Suggestion 

 1  Topic Subscribe

Monday, February 17 - 12:02 pm - Copyright © 2000-2020 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online