RunRyder RC
WATCH
 1 page 1240 views POST REPLY
05-10-2013 09:17 AM  6 years ago
Topic Vote0Post 1
Will B

rrVeteran

Bicester, Near Oxford, UK.

MyPosts All Forum Topic
YGE 120 HV
Guys,

this speed controller is driving me mad.

I have the prog card 3 and the problem I am having is that I cannot get the motor to go to full power ( i.e. light on ESC fully off. )

Also the motor activates only at half stick and above. Obviously this shouldnt be the case!

Can any of you guys help here??

Maybe I'm missing something??
Cheers, Will.
SHARE  PM  EMAIL  GALLERY  Attn:RR  Quote
05-10-2013 10:36 PM  6 years ago
Cadriel

rrNovice

Auckland, NZ

MyPosts All Forum Topic
Sounds like you have the governor turned on and perhaps end points are not set.

Try turning the governor off first, then set the throttle endpoints through the sticks.. NOT through the programming card.

Then test.

Then setup your gov if you need.
In a mad world, only the mad are sane.
SHARE  PM  EMAIL  Attn:RR  Quote
05-11-2013 04:33 AM  6 years ago
helitroll

rrVeteran

Southlake, TX

MyPosts All Forum Topic
YGE programming
I used Mr Mel's videos as I always do. For some reason it did not work for me with the YGE. I could not get the light to go out showing full power. (I may have that backwards.) I went back to the manual and used the programming card III to set the high and low endpoints. The next spool up worked as it should. I am using the 160 on an X-7 and it is working great. I am very happy with the YGE.
SHARE  PM  EMAIL  GALLERY  Attn:RR  Quote
05-11-2013 11:50 AM  6 years ago
Will B

rrVeteran

Bicester, Near Oxford, UK.

MyPosts All Forum Topic
OK I'll give it a try!Cheers, Will.
SHARE  PM  EMAIL  GALLERY  Attn:RR  Quote
WATCH
 1 page 1240 views POST REPLY
 Print TOPIC  Make Suggestion 

 1  Topic Subscribe

Thursday, February 20 - 3:01 am - Copyright © 2000-2020 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online