RunRyder RC
WATCH
 1 page 581 views POST REPLY
HomeAircraftHelicopterCentury Radikal G20-30 N640 Hawk Predator › G30 kit Fan Hub, or the one from Zenoah?
04-26-2013 02:30 PM  5 years agoPost 1
Santiago P

rrProfessor

South West, Ohio

My Posts: All  Forum  Topic

Putting together a G30 and right after I put the engine assembly in the rear frames I discovered the among all the engine parts the Zenoah G29 3D max came with ANOTHER fan hub.

The one on the kit "seem" to fit perfectly.

Is the fan hub that came wit the engine any different?

I am at the stage fitting the clutch bell.

thanks

Santiago

PM  EMAIL  HOMEPAGE  GALLERY  Attn:RR  Quote
04-26-2013 02:46 PM  5 years agoPost 2
Carey Shurley

rrElite Veteran

Orlando, FL - USA

My Posts: All  Forum  Topic

yes its different, the boring is slightly deeper

you can modify the bore in the hub in the kit and use it but if you don't either mod it or use the hub that came with the motor the hub will sit slightly higher and will cause an interference issue with the top of the clutch bell on the inside

I'd suggest just using the hub that came with the motor. At this stage of your build its still easy to switch

This ONLY applies to the HWC 3D Max motor as it uses a different crank

Proprietor - Gas Powered Helicopters

PM  EMAIL  GALLERY  Attn:RR  Quote
04-26-2013 03:01 PM  5 years agoPost 3
Santiago P

rrProfessor

South West, Ohio

My Posts: All  Forum  Topic

Thank you Mr Shurley, I much appreciate the guidance.

As you pointed out, it will be easy to swap the hubs at this stage.

Santiago

PM  EMAIL  HOMEPAGE  GALLERY  Attn:RR  Quote
04-28-2013 06:30 AM  5 years agoPost 4
Santiago P

rrProfessor

South West, Ohio

My Posts: All  Forum  Topic

This turned out very ironic.

I tried the fan hub that came with the engine and it was too high, pushing the clutch against the bell,

Went back to the one that cam with the kit and the clutch stack fit perfectly. Oh well

Santiago

PM  EMAIL  HOMEPAGE  GALLERY  Attn:RR  Quote
WATCH
 1 page 581 views POST REPLY
HomeAircraftHelicopterCentury Radikal G20-30 N640 Hawk Predator › G30 kit Fan Hub, or the one from Zenoah?
 Print TOPIC  Make Suggestion 

 0  Topic Subscribe

Monday, October 22 - 2:02 am - Copyright © 2000-2018 RunRyder   EMAILEnable Cookies

The RC discussion world needs to consolidate. RR is now one choice for that. Its software is cutting edge. It hosts on-topic advertising. Help RR increase traffic buy making suggestions, posting in RR's new areas (sites) and by spreading the word.

The RunRyder Difference

• Category system to allow Rep/Vendor postings.
• Classifieds with sold (hidden) category.
• Classifieds with separate view new.
• Answer PMs offsite via email reply.
• Member gallery photos with advanced scripting.
• Gallery photo viewer integrated into postings.
• Highly refined search with advanced back end.
• Hosts its own high end fast response servers.
• Hosts thousands of HD event coverage videos.
• Rewrote entire code base with latest technology.
• No off-topic (annoying) click bait advertising.
Login Here
 New Subscriptions 
 Buddies Online