RunRyder RC
WATCH
 1 page 553 views POST REPLY
HomeAircraftHelicopter
e-
Align
T-REX 600 › 600E pro Swash plate issue DX8
04-25-2013 02:19 AM  5 years agoPost 1
pinball2883

rrNovice

ada michigan

My Posts: All  Forum  Topic

I have a 600E pro with a DFC head and swash plate. I am working on building the heli and i can not get the head to balance out with my balancing block. center its balanced. Throttle up the Elevator Arm is low compared to the rest. when go low throttle low the pitch arm is not balanced. Sub trim makes it worst. Is it a travel issue? should i adjust the travel on my transmitter? I am using a DX8 for my transmitter. Next step is to setup my 3GX after i figure this issue out.

DX8 seems to not like to much sub trim otherwise it jumps from little movement to a large one. in just one click it will jump to all full servo throw. I am new to the DX8 I had a 12X before this

PM  EMAIL  GALLERY  Attn:RR  Quote
04-26-2013 03:50 AM  5 years agoPost 2
dcbusdriver

rrApprentice

Stephens City,VA -USA

My Posts: All  Forum  Topic

If you have leveled it at center stick with sub trim then full travel limits will most likely be out of balance. this can be corrected by adjusting the endpoints for each servo at both low and high positions. It depends on the fbl system you are using as to whether or not you need and/or want to do this as the fbl system with adjust for level as the swash plate translates. Follow the recommendations for your system. Hope that helps.

beating the air into submission...........cool!

PM  EMAIL  GALLERY  Attn:RR  Quote
04-27-2013 02:48 AM  5 years agoPost 3
pinball2883

rrNovice

ada michigan

My Posts: All  Forum  Topic

that does help. I am using a 3GX

PM  EMAIL  GALLERY  Attn:RR  Quote
WATCH
 1 page 553 views POST REPLY
HomeAircraftHelicopter
e-
Align
T-REX 600 › 600E pro Swash plate issue DX8
 Print TOPIC  Make Suggestion 

 1  Topic Subscribe

Tuesday, August 21 - 7:05 am - Copyright © 2000-2018 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online