RunRyder RC
WATCH
 1 page 825 views Post Reply
Home✈️Aircraft🚁HelicopterFuel-Helicopters New or Limited ActivityAvant › Shims for tail output gears?
04-25-2013 12:15 AM  7 years ago
Topic Vote0Post 1
carcrasher

rrElite Veteran

east coast

MyPosts All Forum Topic
Shims for tail output gears?
What is the part number for the shims (.1,.2.3mm)? Also there is a .5mm gap between my auto hub and my one way bearing, is this normal?

SHARE  PM  EMAIL  GALLERY  Attn:RR  Quote
04-25-2013 08:12 AM  7 years ago
jbiter

rrKey Veteran

Sebring, FL

MyPosts All Forum Topic
Try this

AV00-200-307 - 6mm ID x 0.1mm Shim
AV00-200-308 - 6mm ID x 0.2mm Shim
AV00-200-309 - 6mm ID x 0.3mm Shim

Jeff
SHARE  PM  EMAIL  GALLERY  Attn:RR  Quote
04-25-2013 12:33 PM  7 years ago
carcrasher

rrElite Veteran

east coast

MyPosts All Forum Topic
Thanks for the reply. I found the set. Also the play w/the main gear is normal.
SHARE  PM  EMAIL  GALLERY  Attn:RR  Quote
04-26-2013 02:11 AM  7 years ago
Justin Stuart (RIP)

rrMaster

Plano, Texas

MyPosts All Forum Topic
You are wanting to put shims on the main shaft? Is this correct?Avant RC
Scorpion Power Systems
Thunder Power RC
Kontronik Drives
SHARE  PM  EMAIL  GALLERY  Attn:RR  Quote
04-26-2013 02:14 AM  7 years ago
carcrasher

rrElite Veteran

east coast

MyPosts All Forum Topic
No. The tail pick up gear. I found the part number for the shims. I was showing this small gap cause I wasn't sure if it was normal, it's normal so on with the (re)build.
SHARE  PM  EMAIL  GALLERY  Attn:RR  Quote
04-26-2013 12:46 PM  7 years ago
Justin Stuart (RIP)

rrMaster

Plano, Texas

MyPosts All Forum Topic
When you have the main gear and main shaft in the frames, pull up on the top of the main shaft while simultaneously pushing down on the collar. Then tighten the collar with both screws. This will eliminate any up-and-down play in the main shaft.Avant RC
Scorpion Power Systems
Thunder Power RC
Kontronik Drives
SHARE  PM  EMAIL  GALLERY  Attn:RR  Quote
WATCH
 1 page 825 views Post Reply
Home✈️Aircraft🚁HelicopterFuel-Helicopters New or Limited ActivityAvant › Shims for tail output gears?
Print TOPIC

 1  Topic Subscribe

Saturday, September 19 - 12:50 pm - Copyright © 2000-2020 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online