Joliet, Illinois USA
Well I got a fix now. Took and extension and chopped off the male end? Shortened the wire down to about 2 1/2in, crimped an soldered the pins for the male servo connector minus using the plastic end. Heat shrink on each end and bent pins at a 90degrees. From there I put heat shrink over the servo wire for added protection since the wire will run inside the case under the board. Also added a small piece of servo tape for padding so nothing moves around. And jus a small spot filed down on the opposite side where the wire comes out. Now th sensor plugs in on the other side. Pics posted soon.T-Rex 700n vbar, Logo 600 vbar, Rave 450 350mm 6s beastX, Devil 480 6s vbar... Need I say more???