RunRyder RC
WATCH
 1 page 464 views POST REPLY
HomeRC & Power✈️Aircraft🚁HelicopterFlybarless Rotor Head SystemsV-Bar › Trex 600e pro question...
01-09-2013 12:15 AM  7 years ago
Topic Vote0Post 1
pulsar110

rrApprentice

USA

MyPosts All Forum Topic
Trex 600e pro question...
I have a 600 pro that I bought a while back. I got it used and already setup so all I had to do was check over a few things and program.

Now Iv had a crash and am rebuilding things. Im not sure how far out to put the ball on the DS650 servo for the tail.

Any guidance would be appreciated.
Fly it like its a rental...
SHARE  PM  EMAIL  GALLERY  Attn:RR  Quote
01-09-2013 04:40 AM  7 years ago
MNNightflyer

rrNovice

Minneapolis, MN USA

MyPosts All Forum Topic
I have a 550e converted to a 600, and it's on the third hole out from the center on a smaller white horn. Hope that helps
SHARE  PM  EMAIL  GALLERY  Attn:RR  Quote
01-09-2013 06:00 AM  7 years ago
THEDOGGFATHER

rrNovice

new zealand

MyPosts All Forum Topic
I've got mine at 11mm from center I think they recommend 13mm for a 600 size but 11mm seems to work for me.
SHARE  PM  EMAIL  Attn:RR  Quote
01-09-2013 02:37 PM  7 years ago
doug p

rrApprentice

blaine mn USA

MyPosts All Forum Topic
Go buy the numbers in the VBAR when srtting up the tail that will tell you were you need to be.
SHARE  PM  EMAIL  Attn:RR  Quote
01-09-2013 06:22 PM  7 years ago
pulsar110

rrApprentice

USA

MyPosts All Forum Topic
Maybe Im blind I didnt see the numbers when I looked thru the setup on the vbar website or in the setup program. Ill look again.Fly it like its a rental...
SHARE  PM  EMAIL  GALLERY  Attn:RR  Quote
01-09-2013 11:14 PM  7 years ago
doug p

rrApprentice

blaine mn USA

MyPosts All Forum Topic
They should be between 90-110 when in setup mode
SHARE  PM  EMAIL  Attn:RR  Quote
01-09-2013 11:27 PM  7 years ago
pulsar110

rrApprentice

USA

MyPosts All Forum Topic
That part I have setup fine in the software. I was just trying to figure out how far out on the servo wheel the ball needs to be. Ill go with the 13mm that was mentioned and go from there. Where I got in a jam is that in the crash the servo wheel broke and the piece with the ball was gone so I had no reference point.Fly it like its a rental...
SHARE  PM  EMAIL  GALLERY  Attn:RR  Quote
WATCH
 1 page 464 views POST REPLY
HomeRC & Power✈️Aircraft🚁HelicopterFlybarless Rotor Head SystemsV-Bar › Trex 600e pro question...
 Print TOPIC  Make Suggestion 

 2  Topic Subscribe

Sunday, April 5 - 10:37 am - Copyright © 2000-2020 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online