Carthage MO USA
My Posts: All Forum Topic
My Classified Feedback
Add Classified Feedback
I have a L/N Taig micro lathe,Made in USA by true craftsmen.
The lathe and 3 jaw chuck have been used seven or eight times,the 4 jaw chuck,compound cross slide,parting tool holder and cutter as well as the collet set and ball bearing live center have never been used.The DC motor I am including will operate from 6 to about 20 volts and give you variable speeds between the 6 ratio's on the pulleys.
I have acquired a new Austrian made Emco lathe so I need to sell this fine high quality machine to make room.The lathe will turn approx. a 4.5 inch dia. up to about 8 inches in length.
PLZ PM any questions.