RunRyder RC
WATCH
 1 page 538 views Post Reply
Home✈️Aircraft🚁Helicoptere-BladeBlade 130 › Gyro programming issue
12-04-2012 05:34 AM  7 years ago
Topic Vote0Post 1
honda411

rrKey Veteran

Surprise, AZ USA

MyPosts All Forum Topic
Gyro programming issue
So I recently got my 130x and want to lower the tail gain just a point or two. Im using the DX8 and did as the paper/ instructions say for entering the secret menu.
I put all travels back to 100% to be sure, and proceeded as instructions say.
Move throttle to full 100% before turning on the tx and plug in the heli. Blue LED goes solid and initializes. Then nothing. It wont show a red, blue or whatever LED other than the solid blue one that normally comes on.
Any help would be appreciated thanks.
HeliDirect Field Rep, Synergy N7 w/ OS 105, Torq Servos, Cyclone/ Rail blades
SHARE  PM  EMAIL  GALLERY  Attn:RR  Quote
12-04-2012 05:36 PM  7 years ago
Funky Trex

rrElite Veteran

Westerville, OH - USA

MyPosts All Forum Topic
Sounds like it is not seeing 100% throttle when powering up the heli. Try moving your throttle endpoint up to 125
SHARE  PM  EMAIL  GALLERY  Attn:RR  Quote
12-04-2012 06:22 PM  7 years ago
cwright

rrKey Veteran

Blossvale New York

MyPosts All Forum Topic
Make sure your throttle curve has 100 for the last point. Ran into this before. Chuck
SHARE  PM  EMAIL  GALLERY  Attn:RR  Quote
12-04-2012 10:12 PM  7 years ago
honda411

rrKey Veteran

Surprise, AZ USA

MyPosts All Forum Topic
Finally got it to work. Thanks. Throttle curve was at 80%HeliDirect Field Rep, Synergy N7 w/ OS 105, Torq Servos, Cyclone/ Rail blades
SHARE  PM  EMAIL  GALLERY  Attn:RR  Quote
WATCH
 1 page 538 views Post Reply
Home✈️Aircraft🚁Helicoptere-BladeBlade 130 › Gyro programming issue
Print TOPIC

 1  Topic Subscribe

Saturday, October 31 - 2:46 am - Copyright © 2000-2020 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online