RunRyder RC
WATCH
 1 page 761 views POST REPLY
HomeAircraftHelicopterHIROBOHirobo Turbulence › Turbulance D3 Questions
06-01-2012 09:26 PM  6 years agoPost 1
Flying Brian

rrElite Veteran

St. Clairsville, Ohio

My Posts: All  Forum  Topic

As I'm progressing through the build, some questions are arising. Any help will be greatly appreciate.

As I build the Tail Housing assembly and install it to the tail shaft, I can take my middle finger and thumb, and squeze the tail grips together. Is this movement supposed to be there?

Thanks

"I just don't Listen" "

PM  EMAIL  GALLERY  Attn:RR  Quote
06-02-2012 01:07 AM  6 years agoPost 2
Dr.Ben

rrMaster

Richmond, VA, USA

My Posts: All  Forum  Topic

If you are referring to a bit of endplay in the grips, that is normal.

Ben Minor

Peak Aircraft/Team Minicopter Team Futaba Team Kontronik USA

PM  EMAIL  GALLERY  Attn:RR  Quote
06-02-2012 01:13 AM  6 years agoPost 3
Flying Brian

rrElite Veteran

St. Clairsville, Ohio

My Posts: All  Forum  Topic

Yes I am. Thanks

are you guys securing the tail housing through the boom, using the holes in the boom? The directions don't call for it?

"I just don't Listen" "

PM  EMAIL  GALLERY  Attn:RR  Quote
06-02-2012 02:50 AM  6 years agoPost 4
Bugcatcher

rrApprentice

Perth, Australia

My Posts: All  Forum  Topic

No there is no end to secure the boom as it is a belt drive. The holes are for the EX tail unit(metal upgrade).

Also avoid pushing the tail grips together otherwise you will push the small o-rings over the inner edges of the hub.

PM  EMAIL  GALLERY  Attn:RR  Quote
WATCH
 1 page 761 views POST REPLY
HomeAircraftHelicopterHIROBOHirobo Turbulence › Turbulance D3 Questions
 Print TOPIC  Make Suggestion 

 2  Topic Subscribe

Monday, July 23 - 6:43 pm - Copyright © 2000-2018 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online