My Posts: All Forum Topic
Lol, before you go into the PC screen and touch anything, go into transmitter and disable any swash ring, link. comp., swash mix, and any acceleration features and turn dial on 3GX back to 12 o'clock position. Now go into DIR mode and set the 3GX to 8deg ele. and right aileron using swash function in TX. Also set the amount of collective pitch also using swash function in your TX to between 12-13 deg. What ever percentage gives you that work with it. Do not use excessively long servo horns or or too short, you will lose resolution or speed, the 3GX reference will be off also. U should also not exceed 13 deg, I used 14 deg. Very important to get an accurate reading.
Before moving on to next menu leave TX mid-stick or swash at zero degrees whenever moving to next menu.
Now press button on 3gx to move to next menu.
Now teach 3gx where your end point is by moving ele. fore and release it back to center stick.
Next press button on 3GX again to go to next menu. Set swash correction, reverse if not correcting in right direction.
Next, press button again to get to next menu to teach 3GX where ail. end point is, just hold right on ail. gimble and release back to center.
Next do the same for swash Aileron correction as you did for ele.
You are now done with swash.
Next set up your tail like you would any 750-780, 3G gyro.
Now you can go into the PC screen and fiddle, but do not touch the aileron and ele. travel limit.
If you do not have a PC, then you will have to learn the new flight mode settings that is now added to 3GX 2.0, that's right, all settings can be done in the 3GX. I wish Align had simplified the settings on PC and on the 3GX flight menu. It can be overwhelming to fiddle with and take away quality time from flying.