RunRyder RC
WATCH
 1 page 715 views POST REPLY
HomeAircraftHelicopterFlybarless Rotor Head SystemsV-Bar › Mini VBar/Jive wiring and setup question
03-07-2012 01:54 PM  6 years agoPost 1
Climax

rrVeteran

West London, United Kingdom

My Posts: All  Forum  Topic

I'm about to install and setup my first mini VBar and have a couple of basic questions.

I'm planning to use it with 2 DSMX satellite RXes and will use the following physical connections.

RD = Tail rotor servo
Ch1 ... 3 = Swashplate servos
RX A = not used
RX B = ESC signal output
RX C = can be used as 2nd RC voltage input
RX 1 = Satellite 1
RX 2 = Satellite 2

I'm also using a Jive 80+ HV and would like to connect it's second power output to RX C.

I believe that the Jive outputs logging/debug data on this second port, so when I connect it to the Mini VBar (using RX C) do I need to remove the signal wire?

I also have a question on bank switching. Clearly this requires a control channel, and I assume that I can pickup an appropriate one internally from the available Spektrum channels via the satellite RXes?

Many thanks!

PM  EMAIL  HOMEPAGE  GALLERY  Attn:RR  Quote
WATCH
 1 page 715 views POST REPLY
HomeAircraftHelicopterFlybarless Rotor Head SystemsV-Bar › Mini VBar/Jive wiring and setup question
 Print TOPIC  Make Suggestion 

 1  Topic Subscribe

Wednesday, July 18 - 1:59 pm - Copyright © 2000-2018 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online