RunRyder RC
WATCH
 1 page 471 views Post Reply
Home✈️Aircraft🚁HelicopterGasser Model RC HelicoptersOther › Spectra elevator control rod
12-18-2011 01:31 PM  9 years ago
Topic Vote0Post 1
flyinfriend

rrApprentice

North American continent

MyPosts All Forum Topic
Spectra elevator control rod
Hi,

I am rebuilding my Spectra after an unplanned auto, servo arm snapped on throttle. I rebuilt a couple of servos and I'm re-installing them. I noticed the rod going from the elevator bellcrank to the elevator servo has an upward slant from back to front. I am using the Futaba Large servo wheel on all servos and this is the only one that is not in-line. Doesn't this throw off the geometry and how much the swash elevator responds in relation to the aileron servos when adding collective??

Thanks
SHARE  PM  EMAIL  GALLERY  Attn:RR  Quote
12-18-2011 02:25 PM  9 years ago
ocr231

rrApprentice

Webster MA

MyPosts All Forum Topic
Hi Tom,
That's ok.Just make sure that your servo wheel and bell crank are 90%.Then level you swash plate like you normally would.
SHARE  PM  EMAIL  GALLERY  Attn:RR  Quote
12-18-2011 10:05 PM  9 years ago
flyinfriend

rrApprentice

North American continent

MyPosts All Forum Topic
Thanks a lot Adam, makes sense now.
SHARE  PM  EMAIL  GALLERY  Attn:RR  Quote
WATCH
 1 page 471 views Post Reply
Home✈️Aircraft🚁HelicopterGasser Model RC HelicoptersOther › Spectra elevator control rod
Print TOPIC

 2  Topic Subscribe

Saturday, June 19 - 5:22 am - Copyright © 2000-2021 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online