RunRyder RC
WATCH
 1 page 449 views POST REPLY
HomeAircraftHelicopter
e-
Electric Motors-Controllers-ESC
Other › Where can I get motor shaft for kontronic pyro?
08-02-2011 04:22 AM  6 years agoPost 1
Tommy8275

rrVeteran

Mount Juliet, TN

My Posts: All  Forum  Topic

Where can I get motor shaft for my Pyro 700-52? How hard to install one of this shaft are they easy to remove it? Any tip trick how to? I also plan to install my scorpion motor shaft too.

Tommy K

PM  EMAIL  GALLERY  Attn:RR  Quote
08-02-2011 04:54 AM  6 years agoPost 2
Yeehaanow

rrApprentice

Vermont

My Posts: All  Forum  Topic

It is a bit of a risk because you could mess up the hole and it will never run true. You can get a shaft at https://sdp-si.com/eStore/ but you'll need to grind the flats.
Take the collar off the top then pull the motor apart. (pulls hard) If you heat the can in the oven at 225 deg F for about 10 minutes you can tap or press the shaft out. Don't forget to take out the bottom sest-screw first. Putting the new one in straight might be the tricky part. Put the shaft in the freezer for a while and heat up the can again and it should go in easier.

-Tim

PM  EMAIL  HOMEPAGE  GALLERY  Attn:RR  Quote
WATCH
 1 page 449 views POST REPLY
HomeAircraftHelicopter
e-
Electric Motors-Controllers-ESC
Other › Where can I get motor shaft for kontronic pyro?
 Print TOPIC  Make Suggestion 

 2  Topic Subscribe

Monday, July 23 - 11:09 am - Copyright © 2000-2018 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online