RunRyder RC
WATCH
 1 page 1154 views Post Reply
Home✈️Aircraft🚁Helicoptere-AlignT-REX 550 › 550e ADK Frame Brace
04-28-2011 06:58 AM  10 years ago
Topic Vote0Post 1
OnTheSnap

rrApprentice

Santa Clara, Ca

MyPosts All Forum Topic
550e ADK Frame Brace
I've been struggling with stripping gears and breaking pinions on my 550e. My best theory is that there is just too much frame flex between the motor and main gear. I came across a very cool new frame brace at GrandRC today and figured I'd give it a try. It connects the lower bearing block to the motor mount, giving it way more rigidity and a fixed inflexible mesh.

Only a couple flights with it so far, but I have high hopes that my chronic stripping issue is behind me.

http://grandrc.chainreactionweb.com...opn8e7dbta5che0

MSH USA -- Cyclone -- Jeti -- Xnova
SHARE  PM  EMAIL  GALLERY  Attn:RR  Quote
04-28-2011 07:02 AM  10 years ago
philip 01

rrElite Veteran

ft worth

MyPosts All Forum Topic
i ended up installing a 700 nitro main gear and a revco 18 tooth pinion.

then started stripping tail gears. all good with the 600 boom and belt. so far.
SHARE  PM  EMAIL  HOMEPAGE  GALLERY  Attn:RR  Quote
04-28-2011 07:24 AM  10 years ago
OnTheSnap

rrApprentice

Santa Clara, Ca

MyPosts All Forum Topic
The thought has crossed my mind and I may still go there. But either way this seems to really stiffen up the frames in the high stress area of the frame. Still running the stock 1.6mm which has too much give near the motor and main shaft IMO.MSH USA -- Cyclone -- Jeti -- Xnova
SHARE  PM  EMAIL  GALLERY  Attn:RR  Quote
04-28-2011 07:37 AM  10 years ago
philip 01

rrElite Veteran

ft worth

MyPosts All Forum Topic
yes. the 2mm frames make a huge difference with a high torque motor.

i also installed the kde frame stiffener. made a difference.
SHARE  PM  EMAIL  HOMEPAGE  GALLERY  Attn:RR  Quote
04-28-2011 06:46 PM  10 years ago
esmoglo

rrKey Veteran

Florida USA

MyPosts All Forum Topic
Looks nice but a bit much $$ for this mod but I think a set of 2.0MM frames would be much better. I have the stock CF frames with the KDE rear stiffener and center frame support and it seems ok. My buddy has the 2.0MM frames and its very firm with minimal flex and its well worth the upgrade for only $99 bucks and the Custom Heliparts 2.0MM frames have the center drilled out for the third bearing block if you want.

Angelo
Ugly can be fixed stupid is forever!
SHARE  PM  EMAIL  GALLERY  Attn:RR  Quote
WATCH
 1 page 1154 views Post Reply
Home✈️Aircraft🚁Helicoptere-AlignT-REX 550 › 550e ADK Frame Brace
Print TOPIC

 1  Topic Subscribe

Friday, September 17 - 4:12 am - Copyright © 2000-2021 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online