RunRyder RC
WATCH
 1 page 420 views POST REPLY
HomeAircraftHelicopterMain Discussion › ccpm set up
01-16-2011 07:20 AM  7 years agoPost 1
pilot65

rrNovice

Lafayette louisiana

My Posts: All  Forum  Topic

Hello, IM in need of some help, Im trying to set up my helis from scale type flying to all out 3D the problem im having is when i go to idle up 1 or 2 the swash gives me positive pitch when it should but when im at bottom stick and i should have negative stick the swash goes ack in to posive pitch, in other words it' not giving me equal neg and positive the way it should.
I could use some help at this point and this happens on both my raptor 30 and my frenzy 50 and the raptor iset up with eccpm conversion kit so obviously it's something im setting up wrong.

PM  EMAIL  GALLERY  Attn:RR  Quote
01-16-2011 07:42 AM  7 years agoPost 2
Dood

rrProfessor

Wescanson

My Posts: All  Forum  Topic

Your starting position is important, that is, 0° pitch at exactly center travel on each ccpm cyclic servo.

Here are two how-two guides you should check out (do them in order)

I agree with Jim's advice except the part where he says its important to follow the directions in the manual. I am strongly against using manufacture specified linkage lengths.

http://rchelimag.com/pages/howto.php?howto=6&page=5

and this
http://rchelimag.com/pages/howto.php?howto=11&page=5

  ▲
▲ ▲

PM  EMAIL  GALLERY  Attn:RR  Quote
WATCH
 1 page 420 views POST REPLY
HomeAircraftHelicopterMain Discussion › ccpm set up
 Print TOPIC  Make Suggestion 

 2  Topic Subscribe

Saturday, July 21 - 4:53 pm - Copyright © 2000-2018 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online