RunRyder RC
 0  Topic Subscribe
WATCH
 1 page 522 views TOPIC CLOSED
HomeAircraftHelicopterAlignT-REX 700N › Mainshaft
01-02-2011 06:47 PM  7 years agoPost 1
PC12DRVR

rrKey Veteran

USA

My Posts: All  Forum  Topic

I am converting my 700N to a flybarless heli using a 3G head. I noticed on my 700E 3G uses a shorter mainshaft part 700FL, so I fitted one to my 700N and it fits, but the bearing blocks are different on the 700N, so I measured the spacing and they are both the same, about 19mm at mid stick.

Has anyone else tried this? and if so how did it work out? I am guessing it should work fine with the spacing being the same.

PM  EMAIL  GALLERY  Attn:RR
01-02-2011 07:22 PM  7 years agoPost 2
Kevin Dalrymple

rrKey Veteran

Indianapolis

My Posts: All  Forum  Topic

PM  EMAIL  GALLERY  Attn:RR
01-02-2011 08:20 PM  7 years agoPost 3
ckd

rrApprentice

Saugus CA

My Posts: All  Forum  Topic

you can also go to aligns site and they will tell you what heli each part is for. With the main shaft they show for 700e and 700n.

PM  EMAIL  Attn:RR
WATCH
 1 page 522 views TOPIC CLOSED
HomeAircraftHelicopterAlignT-REX 700N › Mainshaft
 Print TOPIC  Make Suggestion 

 0  Topic Subscribe

Tuesday, June 19 - 6:06 am - Copyright © 2000-2018 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online